Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other

Question

Question:

Is x-track as strong as e-track? Is there any advantage of using e-track over x-track?

asked by: Jarrod

0

Expert Reply:

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed, e-tracks are the better choice. If you are setting up something in your home workshop, you might be better served with x-tracks. The strap systems are interchangeable between the two systems.

You can see this if you compare the E-Track and X-Track I have listed below.

Erickson Horizontal E-Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1, part # E19148
CargoSmart Horizontal or Vertical X-Track - Matte Black - Steel - 667 lbs - 5' Long, part # 3481788

As you can see, each track is 5' in length, but the E-Track has a higher weight rating than the same length X-Track.

I have included product description links, video review links, and a weblink to our e-track and x-track offerings below.

expert reply by: Mark Smith

0

Answer 1

On an 4 foot long section of E-track #EM19147 and 2 screws every 16 inches that is a total of 6 screws in the aluminum frame. This most likely will not get you near the capacity of the E-track. I recommend bolting through the aluminum frame so that…

view full answer...

Answer 2

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

view full answer...

Answer 3

The Erickson E-Track is very versatile so they isn't a specific size or model for your 5 x 8 Haulmark Transport Deluxe Cargo Trailer, just install as much or as little as you want, on the deck or on the wall. I have included a link to all of the…

view full answer...

Answer 4

For a 3500 lb Electric Jack, I recommend the Bulldog Powered-Drive Trailer Jack - Drop Leg - A-Frame - 14" Lift - 3,500 lbs - Black #BD500187. This jack uses a 12 volt system, so it is compatible with your 7-way although a battery is always a…

view full answer...

Answer 5

The trailer jack should very much NOT be powered by the breakaway battery. That was likely done by the previous owner for convenience. The breakaway battery is a dedicated battery for the breakaway system only. It needs to be able to apply the…

view full answer...

Answer 6

To create barn doors out of your ramp door, you will need hinges and a latch. I suggest a latch/lock system like the Universal Cam-Door Lock for Enclosed Trailers - 1" Keeper, #383200. This will use a 3/4 inch diameter pipe that you'll have…

view full answer...

Answer 7

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

view full answer...

Answer 8

This is definitely a way to keep power to your refrigerator and prevent it from completely draining the battery on your trailer, though I will say that it is a very unique one. With that being said, as long as you do use 30 amp circuit breakers, like…

view full answer...

Answer 9

Yes, you can use Erickson Horizontal E-Track item #E19148 as front straps to hold down a car. These tracks have a 2,000 lbs maximum capacity per track. You will want to use the etrailer E-Track Backing Plates w/ Hardware item #e96RR for mounting. The…

view full answer...

Answer 10

When you tighten the two nuts on the studs of the Trailer Spare Tire Carrier #DL22128 you were looking at, it will squeeze the tire against the frame which will keep it secure and won't allow it to slide back and forth. I wouldn't hesitate to…

view full answer...

Answer 11

If the distance from the center of one bolt hole to the center of the adjacent bolt hole is truly 2-3/4 inches, then you have a 5 on 4-3/4 bolt pattern. I have included a link to an FAQ article that shows a couple of ways you can determine bolt…

view full answer...

Answer 12

A single spare tire mounted in your trailer will not have too much effect on tongue weight but if your application means installing multiple E-Track spare tire holders #RA-16HST then you will want to try to distribute the load evenly if possible. For…

view full answer...

Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching