Recommended LED Upgraded Taillights for a 2002 Aliner Camper

Question

Question:

Hello, I have a 2002 Aliner and I want to replace the rear stop, turn and running lights. It is a flush mount and there are 4 wires coming out the back to the present lights: White, red, blue and brown. Do you have any rear LED lights that will work and how do I wire it? thanks

asked by: Gary R

0

Expert Reply:

To upgrade your lights, an exact replacement won't really be possibly but retrofitting an upgraded LED option will be super easy. For this, I recommend the Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens# CE86FR by command electronics.

The light has more wires than normal but that is because you can wire each light with 4 functions. The black wires are for the tail light, the red wire is the stop and turn, the purple wire is for the reverse function, and the white wire is the ground. You'd need to test the wires on the trailer to verify function.

Check out the attached video review of this product for more information.

expert reply by: Conner L

0

Answer 1

Hello David, thanks for reaching out. The matching passenger side light to the Optronics #OPT34KB is the following: - Optronics LED RV Tail Light - Stop, Tail, Turn, Backup - Oblong - Passenger Side #OPT54KB

view full answer...

Answer 2

It looks like the 2014 Rockwood Aliner uses the RV Tail Light part #RVSTB60 for passenger side or part #RVSTB61 for driver side.

view full answer...

Answer 3

I will say that it's not uncommon to have the open hatch on your fan open facing the direction of travel, so the orientation of your fan isn't a huge concern; they normally do a fairly good job of keeping most of the moisture out of your…

view full answer...

Answer 4

Thanks for the additional information and picture of the brake light on your 2020 Jayco Redhawk. I have a solution for you but those lights are attached to a single board and not able to be separately replaced or even repaired. The replacement light…

view full answer...

Answer 5

Hello again John; when First Brands took over as the parent company for Bargman they discontinued most of their lights. That includes the direct replacement for the 30-91-010 and 30-91-011. Typically we recommend the the Peterson Trailer Tail Light…

view full answer...

Answer 6

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 7

What you have there are the Command 003-20 incandescent tail lights. Although we do not have the incandescent replacement, we do have the LED version which is the #CE86FR. You will want to keep the lights the same way they are now with the brake…

view full answer...

Answer 8

For your horse trailer with Dexter Torflex 3500 lb axles, you will need the Torflex Lift Kit - Tandem Axle - 2-5/8" Lift #K71-707-02 along with two sets of the Dexter Axle Torflex #10 Axle Side-Mount Frame Installation Hardware Kit #DX54FR which…

view full answer...

Answer 9

While we do not have an exact replacement for the Winnebago tail light 152070-01-000 you may be able to fit the Fusion LED Hardwired Trailer Light #OPT74NR. This is a 4" round light with the similar red an white lens allowing it to act as a tail…

view full answer...

Answer 10

We do have a solution for you, however, you will not be able to power reverse lights on a trailer with a 4-pin trailer connector. The reverse lights on a trailer must receive power from the reverse lights on the tow vehicle. To do this, you will want…

view full answer...

Recommended LED Upgraded Taillights for a 2002 Aliner Camper

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching