Recommended Hub and Drum Assembly To Replace Redline HD84546BX

Question

Question:

Can you cross this trailer part # to your drum HD84546BX this is a Trailer parts pro number. Thanks for your help

asked by: Kenton S

0

Expert Reply:

Absolutely!

The HD84546BX you mentioned is a 10"x2-1/4" hub and drum assembly with a 5 on 4.5" bolt pattern for a 3500lb axle. This hub uses inner bearing # L68149, outer bearing # L44649, and grease seal # RG06-050.

While we do not have this exact hub and drum assembly we do offer the Trailer Hub and Drum Assembly # AKHD-545-35-EZ-K which uses the same inner bearing, outer bearing, and grease seal and will be an exact replacement. This assembly includes the required bearings, races, grease seal, grease cap, and lug nuts.

If you also need the replacement brake assemblies you can use the Electric Trailer Brake Kit # AKEBRK-35-SA and Mounting Hardware # BRKH10B.

I included videos for all of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

Hello Jerry, Great question. It all depends on on if it is compatible. If your current set up is not a topwind coupler then it isn't going to work because the #GCSQTW-30008 does not use traditional pin-adjustment holes (please refer to picture I…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 4

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 5

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

view full answer...

Recommended Hub and Drum Assembly To Replace Redline HD84546BX

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching