Battery Box Recommendation for GC2 Group Size 6 Volt Battery

Question

Question:

Hello. I’m looking for battery box for Interstate, GC2 Deep Cycle Extreme GC2-ECL-UTL battery. Having a hard time matching the dimensions with this battery. Your help is appreciated.

asked by: George

0

Expert Reply:

For your GC2 Deep Cycle Extreme GC2-ECL-UTL battery, I recommend the Snap-Top Battery Box with Strap for 6V Batteries - Vented, part # 329-HM306BKS.

It is compatible with battery sizes ranging from 8-5/8" long x 9-5/8" tall x 5-5/8" wide up to 10-5/8" long x 11-3/16" tall x 7-5/8" wide, so it will work perfectly with your G62 6V battery that is 10-5/16" long x 11" tall x 7-1/8" wide.

expert reply by: Carla M

0

click to enlarge

Answer 1

Hi Richard, There isn't a beam-style 28 inch wiper blade that fits a 12/4 J-hook, just the frame style. I know that's not what you specifically asked for, but I at least wanted to give you the option, and there are two that fit: - Wiper…

view full answer...

Answer 2

According to ClearPlus the correct replacement windshield wipers for your 2014 Thor ACE motorhome are the ClearPlus 77 Series #CP77281. This is the replacement for both the driver and passenger side.

view full answer...

Answer 3

Hey Eric, Since both of your units run off of one thermostat the Advent, as well as the other options we currently offer would not be a compatible match. You would have to completely replace the Dometic system with something like the Furrion Chill HE…

view full answer...

Answer 4

We have a few idler hub options that use bearings with similar inner diameters to your current setup but you'll need to first verify the axle's capacity and the wheel bolt pattern to determine the best replacement. 5,200lb Axles with a 6 on…

view full answer...

Answer 5

I went out to our warehouse and measured the dimension of the Dexter Replacement Magnet for Dexter 12-1/4" Electric Brake Assemblies, #BP01-306. The magnet measured 4 inches long x 2-1/2 inches wide. This magnet is designed to replace the magnet…

view full answer...

Answer 6

Hello David. The wf-8955pec converter is made to work with lead Acid and AGM batteries since they use the same charging profile. It will not work with lithium batteries though. You can make it lithium compatible by replacing the converter section…

view full answer...

Answer 7

It is possible to use a 7-way vehicle end connector such as #PK12-707E to hook up to a stand-alone battery for your lights. You would need to connect by using 10 gauge wire, #10-2-1, and if you use a deep cell battery as you suggested, a pair of ring…

view full answer...

Answer 8

It appears that the #84 E-Z Lube Spindle #TRU87FR is the correct spindle for your axle. You can confirm that this is the correct part by verifying the measurements of the spindle and brake flange. The landing for the grease seal is 1.719, the inner…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

Replacing pull-out steps won't require a bunch of modifications if we can find a matching fit to your current steps. To find the correct fit we'll need to know the entry height (measurement from the ground up to the mounting bracket) and the…

view full answer...

Answer 11

The vent ports of the Commercial Grade Battery Box #329-HM426 are around the top of the box underneath the lid. See attached picture to see the cut outs along the top of the box.

view full answer...

Battery Box Recommendation for GC2 Group Size 6 Volt Battery

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching