Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If the lowest setting has the bottom of your BulletProof Adjustable 2-Ball Mount item #HD2512 only 6 inches from the ground you may need to check the height of your trailer's coupler. If 6 inches is the position of the BulletProof ball…
view full answer...Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball…
view full answer...When winding an awning you want to wind in the direction that would allow the spring tension to want to pull the awning fabric in. So depending on how you look at the head it could be clockwise or counter-clockwise. So roll the awning like you are…
view full answer...For replacing the Drive Head #LC34FR and Idler Head #LC87FR on a Solera Slide Topper you will want to completely remove the slide topper from your RV/Camper. You will need to insert a pin into the end of the tube end cap(see image) to keep the…
view full answer...Thanks for the pictures! It appears you're needing the: -Replacement Drive Head and Roll Tube for Solera RV Slide-Out Awning #LC34FR. Since just the hex bracket at the end of the roll tube is not available separately, you'll…
view full answer...I have a solution for you, but my contact over at Lippert tells me that you won't be able to replace just those casings on Solera Slide-Out Topper. The parts you need are the Replacement Idler Head and Roll Tube for Solera RV Slide-Out…
view full answer...The use of a hitch expander to go from a 2 inch receiver to a 2-1/2 inch receiver will reduce the tongue weight of the hitch by 50 percent. There isn't a front hitch with a 2-1/2 inch receiver available either. So instead of adapting the…
view full answer...The difference is the color of the pin and clips of the two kits. The Patriot Adjustable Hitch Adapter part #PH67SR has black pin and clips whereas the #PH54FR has red ones.
view full answer...The sleeve adapters used adapt a 2-1/2 inch hitch to fit a 2 inch hitch accessory do not diminish the towing capacity of the hitch or the accessory installed in the hitch. We have the Curt hitch reducer part #C45405 that would work well for your…
view full answer...I contacted our representative at Convert-A-Ball and the weight capacity of the ball mount adapter #BA-1 is 10,000 pounds and tongue weight capacity is 2,000 pounds. It bolts right onto your weigh distribution shank such as the Convert-A-Ball…
view full answer...I pulled the Convert-A-Ball Ball Mount Adapter, #BA-1, and an Equal-I-zer weight distribution shank and I found that they do work together. The bolt holes for #BA-1 match the bolt holes on most weight distribution shanks, but it has not been tested…
view full answer...To connect your Blue Ox tow bar, such as their Alpha #BX7380, to your Wrangler Unlimited's towing bumper's 1-inch D-rings you will want adapter kit #BX88358. This includes the 7/8-inch pins and retaining clips. You can see how…
view full answer...Related Searches
Filter Your Search
Contact and Help