Hey Lyn! The Malone Crossbar Conversion Kit for Standard Utility Trailer #MPG475 will definitely work on a trailer like yours. The lower section is 45" long and will sit down in the trailer and attach to the floor/crossmembers with U-bolts. With…
Yes, I can! To add a crossbars to your utility trailer, I recommend the Malone Crossbar Conversion Kit for Standard Utility Trailer item #MPG475. This kit comes with two 78" crossbars that are 13-3/4" tall when put together. The crossbars…
The correct harness is dependent on specifically the taillights in your 2021 Chevrolet Trailblazer. If the taillights are LED's then you would use the T-One Vehicle Wiring Harness #TK26VR. If your taillights are not LED's then you would use…
The Malone Crossbar Conversion Kit for Standard Utility Trailer #MPG475 may work well on your utility trailer, but it is designed to attach to the frame and not the side rails, so you'd need to install through the floor mesh on your Tractor…
The Malone TopTier Load Bar Kit for Utility Trailers part #MPG493 measures 54" tall from the bottom of the upright to the top of the crossbar. The uprights will fit on the floor of the trailer so if you measure from the floor up 54", that…
I checked with Malone about the Malone Crossbar Conversion Kit for Standard Utility Trailer part #MPG475 and confirmed the weight capacity as 400 lbs evenly distributed.
I recommend the same Draw-Tite Trailer Hitch Receiver #DT55GR you were looking at for your 2024 Chevy Trailblazer. This Class III hitch has a bolt-on installation and concealed cross tube for a nice clean look. It has a max gross trailer weight of…
Yes the Draw-Tite #DT55GRdoes in fact fit your 2021 Chevrolet TrailBlazer! If you also need a ball mount and wiring I recommend the ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit #119250KIT for the…
Yes there is some minor trimming of the bumper fascia/skirt on a 2022 Chevy Trailblazer (all models, including your RS) to install the Draw-Tite Max-Frame Trailer Hitch Receiver #DT55GR. This is needed so the receiver can protrude, but the portion…
To add a 7-Way connector to your 2023 Chevy Trailblazer you will need two separate wiring harnesses. The first harness you'll need will be determined by whether or not you have LED or Incandescent lights. I have listed both options. LED Lights -…
I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS that you referenced would easily fit in place of it and would…
