Hey Joe! We haven't done a lot of installations on the #3460001 and I believe we tied it into a factory switch on the one we did. I would say find any open spot in the dash nearby for installation like the picture below.
Can you tell me what specifically isn't working on the item #HM56009 harness? Are any of the circuits getting power? If not it's most likely a bad control module. I recommend double-checking that your ground is mounted directly to frame of…
Hey Stu, thanks for reaching out! The Weigh Safe Hitch #WS96ZR can definitely be used in the rise position, and the scale will still work in that orientation as well, so you'll be good to go! What are you planning on towing?
The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.
You can use the Brophy Clamp On Camper Tie-Downs #HSAB for your 2018 Ford F-350 Super Duty but we actually recommend going with the Camper Tie-Downs #HSSF instead as they have a slightly different design that better fits your Super Duty. Attached are…
I called my contact at Brophy and they informed me that they tested the Brophy Clamp On Camper Tie-Downs part #HSAB on an aluminum body Ford F-Series pickup and didn't have any problems doing so therefore, yes they will work well for you. If you…
Hey Ivan, thanks for reaching out! The Brophy Slide In Camper Tie-Downs #HSAB are universal, so you'll have to reference the attached photo and compare that to your 2019 Ford F-150 bed sides for fitment. Unfortunately, this kit isn't…
The pricing algorithm can be messed up from time to time but I do know that things like availability, supply and demand, and what other places are pricing it as well have an effect on this. I'll send in a message to our pricing team to look at…
The Grease Seal part #168233 has a double lip so it can be used on a boat trailer and be submersed under water, yes. This is also the correct replacement for the NOK AD2527E Grease Seal that you have now.
The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…
It can be difficult to give a truly accurate estimate for the length of time it takes to install the Custom Third Brake Light Camera for 8" Factory Monitor #3460001 on your 2020 Ford F-350 Super Duty. The time really depends on how comfortable…
The Custom Third Brake Light Camera for 8" Factory Monitor part #3460001 could pretty easily be wired to an existing switch you have in the cab but I would not be able to offer much advice on this as it's designed to be used with the…
