If you have a 4-pole wiring setup now and you want to install a wireless trailer brake controller you will use an adapter like Curt #C57672 or Hopkins #37185. Both install by plugging in to your 4-pole and by making additional wiring connections…
For situations like yours the best solution is a longer mount to get the extra length since the use of a hitch extender cuts the capacity of the hitch by 50 percent. For example, check out the Brophy ball mount part #BM20 which has a drop of 2 inches…
I may have an option that will work for you, but it will depend on the exact weight of your E-bikes. The Inno Tire Hold II Roof Bike Rack - Wheel Mount - Clamp On - Aluminum #INA389 will fit the Yakima Rack and Roll Trailer #Y08107 and will…
We carry a very handy 2 inch ball mount for this exact application. The part is #D210. The ball mount slides and pins into your hitch and the top receiver will accept 2 inch bike racks and hold them above the ball. The Ball Mount has a 500 lb tongue…
You are absolutely right that for your 16-1/2 foot canoe the best option is a trailer because this is going to make it much, much simpler for you to haul your canoe; you'll be able to spend a lot more time in the water and a lot less time loading…
Hi Philip! The shocks on the Yakima Rack and Roll Trailer #Y08107 actually use a pin instead of a bolt. That is the Replacement Shock Pin for Yakima Rack and Roll Trailer #8880182. This has a 14mm diameter and has 4-1/2" of useable length. If…
That's a good question, so I contacted Roadmaster regarding the fit of the Roadmaster Rear Anti-Sway Bar #RM-1129-144. They told me that yes, this bar will fit your 2018 Ram 3500 with factory air suspension as the brackets for mounting the bar…
It sounds like the tail block locking assembly broke on your #Y08106 locking lever. Since your Rack and Roll is the 2015 or newer model the correct replacement part is the #8880334. You can remove the lock core using the control key #Y8007835 and the…
The Replacement Shock Pin for Yakima Rack and Roll Trailer #8880182 measures 4-1/2 inches from the collar to the center of the pin hole. The measurement from the collar to the end of the pin is 4-15/16 inches. I've attached a photo with these…
For your Yakima Rack And Roll 78" trailer #Y08107 you will want to use Replacement Tail Block Locking Assembly for Yakima Rack and Roll Trailer 2015 and Newer - Qty 1 #8880334 and then the Replacement Lock Core and Keys for Yakima Rack and Roll…
Once the rack is locked into the receiver, the end of the cable with the loop is passed around the shank of the rack near the receiver. Then the end of the cable with the locking tip is passed through the loop, and the cable is pulled snug. The…
You do indeed need two safety chains. When the safety chains are attached to the tow vehicle, they should be crossed below the coupler in an X pattern. This is done so that if the coupler should come off of the trailer ball, the crossed safety chains…
