Custom Fit 2013 Toyota Highlander Accessories

To wire your 2013 Highlander with a 7-way and 4 pole connector, you'd first need a functional 4-pole trailer connector. If your Highlander doesn't already have one, you can install it using part #118449. With the 4-pole in place,…

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes, your full-size 19 inch spare tire will be able to remain in place, and the etrailer hitch will indeed fit your 2013 Toyota Highlander with that size spare. The correct part number for your Highlander is the following: - etrailer Trailer Hitch…

In regards to the Furrion RV Tankless Water Heater part #FR98SR, the owner's manual recommends using non-metallic flexible hoses for the gas supply and PEX for the water supply. The gas fittings on the unit are 3/8" female flare and the…

Yes, there should be a washer of some type between the spindle nut and the bearing on your trailer. The washer protects the back side of the bearing from the edges and points on the back side of the spindle nut. There are several types of spindle…

Yes you can use a Bearing Buddy on your current axle setup but you'll have to remove the zerk/grease fitting. What you have now is an EZ lube spindle which allows you to push grease through the middle of the spindle but you can install a Bearing…

If you notice chipped areas on your Draw-Tite Trailer Hitch #76020, for your 2018 Mazda CX-9, the best thing to do is lightly sand that area to get it evened out and then paint over it to prevent the rust from spreading. Since hitches are underneath…

I reached out to my contact at EcoHitch and she verified that the Hidden Trailer Hitch Receiver #306-X7137 will fit with the full size spare tire beneath your 2008 Toyota Highlander. You will want to lower/remove the spare during the installation…

I would be happy to help you set up your 2013 Toyota Highlander for towing. I will start by confirming that the etrailer Trailer Hitch Receiver item #e98858 does fit your Highlander. Since you do not have any vehicle connectors at the rear of your…

Yes, the Mounting Panel #331-TPSI-002 will fit your 2019 Toyota Sienna for installing the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR. You don't see it on the fit list since brake controllers are not commonly installed in your vehicle.…

If you have a 5,000 lb trailer towing weight capacity for your 2013 Toyota Highlander Limited and you will not be filling your tanks before traveling then you should be okay. The difference between your dry trailer weight and the GVWR (Gross Vehicle…