Custom Fit 2012 Toyota Highlander Accessories

We have actually confirmed with Malone that both the 58" #MPG216 and the 65" #MPG217 long Malone AirFlow2 Roof Rack will fit on your 2010 Toyota Highlander. The video that you are referring to is us fitting the 50" version, part…

You will want to use a circuit tester like #PTW2993 to find out where the short circuit is. First check the the power and the ground wire and then work your way to the other functions of your harness. If you find the short is in a wire, you can…

For your 2012 Toyota Highlander Limited, you'll need a hitch, the wiring, a brake controller and an anti-sway system. Based on my research, it looks like Toyota recommends both a braking and a sway control device on a trailer at this weight on…

Hello Vincent, thanks for reaching out. Some 14 gauge wire would be acceptable for the 12v power wire. Generally, we would use a 30 amp circuit breaker for this. To prevent any backfeed you can install a diode like part #RM-690. I hope this helps.…

Since your 2012 Toyota Highlander has a tow prep package you will need Curt T-Connector Vehicle Wiring Harness for Factory Tow Package #56042 which plugs into the vehicle's factory tow package wiring harness behind driver's side trim panel in…

The 195/70R14 tire is a passenger car tire size. A trailer should have a ST rated tire. which means it is a Special Trailer tire. The special trailer tire is designed with stronger sidewalls and can handle higher air pressures which are needed when…

The best way to determine if your 2012 Toyota Highlander has a factory tow package is to have a Toyota dealer run the VIN number in their computer system. They can tell you how the vehicle is equipped that way. If they say you do not have the tow…

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…

If the SumoSprings #CSS-1168 is not picking up enough slack on your 2020 Ford Expedition, you can definitely add on to it. I spoke with SumoSprings and they said it is perfectly fine to add on another #CSS-1168 if the first one isn't getting all…

You will need a 1-1/2" wrench like part #C20001 in order to install the nut on the 2" Hitch Ball part #63845. A 1-7/8" wrench would be much too large.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…