2012 GMC Yukon Trailer Wiring
2012 GMC Yukon Brake Controller
2012 GMC Yukon Front Mount Hitch
2012 GMC Yukon Towing Mirrors
2012 GMC Yukon Base Plate for Tow Bar
2012 GMC Yukon Vehicle Tow Bar Brake System
2012 GMC Yukon Vehicle Tow Bar Wiring
2012 GMC Yukon BOLT brand vehicle and hitch locks
2012 GMC Yukon Roof Rack
2012 GMC Yukon Trunk Bike Rack
2012 GMC Yukon Truck Bed Sliding Tray
2012 GMC Yukon Air Filter
2012 GMC Yukon Exhaust
2012 GMC Yukon Suspension Enhancement
2012 GMC Yukon Transmission Cooler
2012 GMC Yukon Performance Chip Tuners
2012 GMC Yukon Vehicle Lights
2012 GMC Yukon Tire Chains
2012 GMC Yukon Fluid Filters
2012 GMC Yukon Vehicle Sway Bars
2012 GMC Yukon Vehicle Snow Plows
2012 GMC Yukon Salt Spreader
2012 GMC Yukon Vehicle Engine Heaters
2012 GMC Yukon Off Road Lights
2012 GMC Yukon Radiator Fan
2012 GMC Yukon Lift Assist
2012 GMC Yukon Floor Mats
2012 GMC Yukon Nerf Bars - Running Boards
2012 GMC Yukon Trim Kits
2012 GMC Yukon Vehicle Covers
2012 GMC Yukon Grille
2012 GMC Yukon Grille Guard
2012 GMC Yukon Bug Shield
2012 GMC Yukon Side Window Vents
2012 GMC Yukon Mud Flaps
2012 GMC Yukon Vehicle Seat Covers
2012 GMC Yukon Replacement Mirrors
2012 GMC Yukon Windshield Wiper Blades
2012 GMC Yukon Windshield Covers
2012 GMC Yukon Vehicle Air Mattress
Videos
for GMC Yukon Owners
Help Articles
Expert Answers
While the spacers included in the Kit #T68MR will work with your Timbren Springs #TGMRYS4 they do not use the same mounting bolts. Your GMC Yukon uses 3/8" hardware while the spacer kit includes M10 hardware so you would still need to source the…
Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1" to…
The Timbren Spacer Kit item #T68MR has two 1/2" Spacers and two 1" Spacers which all have a 3/8" bolt hole opening. Also included are 3 pairs of different length bolts to ensure you have the correct length.
The Timbren kit part #TGMRCK25D that fits your 2022 Chevy Silverado 2500 would require the lift spacers that have a 3/8 inch diameter bushing hole like the part #A25723-90AH00 which is 1 inch thick or the #TA25722-90P00 for a 1/2 inch diameter…
Since you have a 2.25 inch distance between the Timbren and the frame you'd want the 1 inch Timbren spacer part #A25723-90AH00 which will move that distance to 1.25 inch.
I do have an option for you but SuperSprings does not offer any additional spacers for the SumoSprings Trailer Helper Springs part #SS26MV. That said, we do still have spacers that will work for this, the Timbren Spacer part #A25723-90AH00 for…
The Timbren Active Off-Road Bumpstops part #TABSOSR which are a fit for a 2007 Toyota Tacoma are designed so that there is more space between the spring and frame to allow the suspension to articulate freely when off-road. If you're looking for a…
I spoke with my contact at Super Springs and the SumoSprings Custom Helper Springs, #SSR-204-40, will fit on your 2003 GMC Yukon XL with coil springs as long as it is a 1500 model. These springs are designed to replace your factory bump stops. Once…
I spoke with my contact over at Timbren about helper springs #TGMRYS4. The overall height of the whole assembly is 4-3/4 inches. The spring by itself is 3-3/4 inches. I have included a link to a video showing installation of this kit for you.
The Redarc Tow Pro Liberty part #RED24FR with the install harness part #RED69FR would be the best option for your 2013 GMC Yukon. This puts only a small knob on the dash of your Yukon like you want and gives you a proportional brake controller that…
The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…
I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.