The Westin Fey Diamondstep Rear Bumper #20107 is designed to fit a 2011 E-150, E-250, E-350, and E450, so it will be the correct part for your van. Just to make sure of this, I double checked with Westin and they confirmed this information. As to the…
Vehicle tail light wiring has changed quite a bit over the past few years. There are basically 2 wire systems and 3 wire systems. A 2 wire system has combined brake lights and turn signals. A 3 wire system has separate turn signals and brake lights.…
You will need to start with a 4-way (if you do not have one). For that you would want the #HM11140495. From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller…
For 4-pole trailer wiring for your 2007 Ford E450 van without the factory tow package you can use Curt custom-fit passive harness #C56020 or the Hopkins custom harness #HM11140495 which has a powered converter. Both are shown on the linked page. The…
Hubs will heat up when driving, but if it feels like they are getting too hot, then you will want to look at a few things on your hub. My guess is that the spindle nut is too tight and the added stress on the bearings is overheating the bearings and…
The Mount-n-Lock SafetyStruts Standard RV Bumper Support Brackets part #MO34VR are designed to fit 4" x 4" or 4-1/2" x 4-1/2" square RV bumper. If this is what you have then it will work well for you. It provides a 400 lb weight…
Yes, the TorkLift Lock and Load SideKick #TLA7901 that you referenced will fit a Honda 2200 generator like you mentioned. We had the chance to fit one on this carrier and it worked well. See attached picture. It's also in the review video for…
The side bracket of the 16x21 TorkLift Lock and Load SideKick Cargo Tray #TLA7901 would block the outlets on a Honda EU2000 generator, but there's about a 2" gap between the outlets and bracket so you should still be able to plug into it.
The TorkLift Lock and Load SideKick Cargo Tray, part #TLA7901, can carry any generator that fits on it. The generator needs to have a center handle and be no more than 16 inches wide and 21-1/4 inches long. For the height there are three different…
It sounds like there is a short somewhere along the wiring of your vehicle or trailer that is causing a fuse to blow every time you connect. The first thing I recommend doing is disconnecting the trailer and using a circuit tester like #PTW2993 to…
For your 2003 Ford E-250, I recommend checking out the: -Curt Trailer Hitch Receiver #14055. This is a class IV trailer hitch that has a maximum towing capacity of 10,000-lbs, with a maximum tongue weight capacity of 1,000-lbs, and will work great…
The big differences between a Class IV and a Class V hitch are the capacities and the opening size. Class IV is going to be a 2 inch hitch opening that has tongue weights typically up to 1,200 lbs and total trailer weight of 12,000 lbs. For a Class V…
