Videos
for Toyota Highlander Owners
Help Articles
for Toyota Highlander Owners
Expert Answers
for Toyota Highlander Owners
Yes! The clamps that come with the Yakima BigCatch Kayak Roof Rack w/ Tie-Downs #Y04091 will fit perfectly around your 1-1/4" square crossbars.
view full answer...If you have no power to the trailer wiring harness, the fuse panel is located in the engine compartment. I have attached a drawing that shows where the fuse panels are located on a 2006 Highlander. Per the second attached drawing the fuse for trailer…
view full answer...If your Highlander has an active tow package plug located in the driver's side rear of the cargo area under the floor (see linked instructions for part #C56107 to see where plug is located and how to access it) your Highlander has the tow…
view full answer...Yes, the etrailer Trailer Hitch Receiver #e98857 fits the following: 2004 - 2005 Toyota Highlander 2006 - 2007 Toyota Highlander excluding Hybrid 2006 - 2007 Toyota Highlander Hybrid 2004 - 2006 Lexus RX 330 2007 - 2009 Lexus RX 350 2006 - 2008 Lexus…
view full answer...The etrailer.com hitch part #e98857 that you referenced is compatible with the 2007 Toyota Highlander non-hybrid that you have and will not interfere with the full size spare you have either.
view full answer...Out of the three hitches that are confirmed for your 2006 Lexus RX 330 The etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2 inch #e98857 is best because it has an extra coating of rust resistant paint on it making the…
view full answer...The only difference between the Curt Trailer Hitch Receiver part #13530 and the etrailer Trailer Hitch Receiver part #e98857 for a 2006 Toyota Highlander is finish. The Curt hitch has a shiny finish and the etrailer hitch has a matte finish which…
view full answer...I recommend the etrailer Trailer Hitch Receiver #e98857 for your 2007 Toyota Highlander. This receiver has a solid steel construction with precision, robotic welding to eliminate the chance of rattle when going over bumps. It uses a matte black…
view full answer...I spoke with our installers and they told me that this will happen time to time. They said there are times when the auto manufacturer will have the holes moved just a bit, but they work with them to make it work. They told me that they use a tool…
view full answer...It definitely looks like you found the right connector for a tow package on your 2007 Toyota Highlander Hybrid! With this being the case I recommend using the Curt T-Connector #C56107 because it has higher amp ratings than the Tekonsha T-One #118248.…
view full answer...If you have a factory plug on your 2006 Toyota Highlander then these circuits will be protected by fuses and relays built into the factory fuse box located under your hood. In order to be sure you are looking in the correct locations you will need to…
view full answer...Yes, there are 2 fuses that come with the Curt T-Connector #C56158 for a 2012 - 2016 Honda CR-V. The larger fuse is placed in the red fuse holder while the smaller 10 amp low profile mini fuse is placed into the fuse panel in position 10 (which you…
view full answer...