The Curt #C13900 is width adjustable, determined by where the bolts are installed in the crossbar of the hitch. If the hitch is assembled in its narrowest orientation as explained on page 3 of the linked instructions, it'll fit on frames that are…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
The connection point for trailer wiring on a 2005 Subaru Outback Wagon is usually located behind the paneling on the passenger side, directly below the tail light. I have included a video and the installation details for a similar harness that also…
For your 2005 Subaru Legacy Wagon there are both Class II and Class III trailer hitches available. I recommend a Class III hitch with a 2 inch receiver such as #75560 because it will be stronger and the 2 inch receiver affords you many accessory…
Hey Derek! The Replacement Hitch Bolt for Yakima BigHorn #Y8890200 actually works as an anti-rattle with the threaded portion of the pin. There is no way to modify the pin or add anything to it to make it more secure. If you're still getting a…
You will need to use a 1-1/8" socket to install the 2" Hitch Ball #19258 that you recently purchased. If you check out the attached installation video we mention what size socket to use and also give some other pointers when it comes to the…
Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #118467 may or may not plug into the vehicle's r79 trailer connector. As all of our wiring harnesses we carry are made for automobiles in the U.S, we cannot guarantee an…
We offer a 2 inch hitch ball, part #A-82 with a 3/4 inch shank diameter and a 2-1/8 inch long shank. If you were needing the high rise trailer ball, those are no longer available. Your best bet would be to use a ballmount with a larger rise to gain…
The smallest diameter shank we offer in the high rise hitch balls is 1 inch like with the part #C40034 which is a 2 inch ball with a 2 inch rise built into it. This has a 6,000 lb capacity. I attached a link to a page that has all of the ball mounts…
There is a potential way for you to haul an electric wheelchair with a 2017 Ford Mustang, although there is not an adapter that is going to work. The reason for that is there is just one 1-1/4 inch to 2 inch adapter with rise that works with a Class…
Hey Mike, That number isn't coming back to anything but I might be able to identify the brand by looking at it and go from there to see what it fits. Can you send me a few pictures?
