It sounds like you are trying to pair the Curt Echo part #C51180 to the Bluetooth on your phone which is why the app is not recognizing it. You want to go into your settings on your phone and make sure you disconnect the Bluetooth from the Curt Echo…
It sounds like you are wanting to install a brake controller and wiring for your trailer on your 2001 Explorer. The wires you mentioned will probably not be the wires for the brakes you asked about. If you do not have a factory trailer connector on…
Between the Curt Echo #C51180 and Redarc Tow Pro Elite #RED44FR for your 2019 Nissan Titan I recommend the Redarc as it is a one time install, and very out of the way unlike traditional trailer brake controllers. To install the #RED44FR in your Titan…
I do have a way for you to install a 7-way trailer connector on your 2012 Ford F-150 but the plug in the photo you attached does not have all of the circuits needed for a 7-way trailer connector so there is not one that plugs directly into this.…
The 4-pole wiring kits offered for your 2001 Ford Explorer Sport Trac are hardwired types, Tekonsha kit #18252 and Curt #C58044. I recommend the Tekonsha since it includes the required circuit tester, but if you already own a tester like #PTW2992…
It sounds like your trailer brakes are sticking, but I doubt the problem is the brake controller. However, you can test this by applying the brakes like you normally do while coming to a stop. Once the trailer and vehicle stop get out and unplug your…
There are a couple of things that may cause what you are stating. If you have checked the power draw with a multimeter like #PT89ZR and see the brake power isn't fully disengaging, then I recommend cleaning the ground connection to the magnet and…
One wheel locking up on your trailers brakes could be for a few reasons. The most likely reason is be due to a brake assembly that is out of adjustment. You want to adjust the assemblies so there is only a light drag on them when they are turned by…
There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…
