2013 Honda Ridgeline Tool Box

Hey John, so the correct amount of spring bar tension will be based on the…

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…

The OEM prep package consists of 4…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length…

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only…

I got some information from Yakima and included a diagram of the EXO SwingBase #Y34VR, which is the base part for the EXO SwingBase 2 Tier #Y82VR. Though the measurement from the pin hole to the closest edge of the carrier is not included in said…

I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.

We definitely have an option to get a tonneau cover working with the UWS UWS Truck Bed Toolbox #UWS00030 once installed on your 2022 Ford F-350 long bed. With that said, the Access Toolbox Edition Soft, Roll-Up Tonneau Cover #A61409 is specifically…

I have a great tool box option for your 2022 Ford F-250 that sits below the rails of your truck bed. The UWS Truck Bed Chest #UWS01048 is going to do a great job of wisely using the space in your truck bed while staying below the bed rails. It is…

The pin box on your 2023 Heartland BigHorn 3970RL is a Lippert 1621. The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY38FR will fit the bolt pattern but…

The bolts on the Replacement Tongue for Yakima Exo SwingBase Swing Away Hitch Extender #Y26KV should be tightened to 100 Nm. This can be found on page 2 of the instructions for the Yakima EXO SwingBase Swing Away Hitch Extender -…

Best way is to drill a hole through the floor of the tool box and then through the bed of the truck and then run a bolt through both. This is the best way to secure a tool box.