2008 Honda Ridgeline Tool Box

The OEM prep package consists of 4…

Hey John, so the correct amount of spring bar tension will be based on the…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length…

Hi Eric; the Curt Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger #C52044 will work for your triple axle Kaufmann trailer. This is designed for 1 to 3 axle trailers with electric brakes so triple axle…

I got some information from Yakima and included a diagram of the EXO SwingBase #Y34VR, which is the base part for the EXO SwingBase 2 Tier #Y82VR. Though the measurement from the pin hole to the closest edge of the carrier is not included in said…

The UWS tool box part #UWS01039 that you referenced is made from 13 gauge aluminum which is .090 of an inch thick.

The UWS A-Frame Trailer Toolbox #UWS01039 measures…

I can help you find the right assemblies, but I do not know exactly which ones you have on your trailer. To pick out the correct brake assemblies for your trailer you need to know a few things. You will want to measure the inner diameter of your…

I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible.…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…