2010 Ford F-350 Super Duty Truck Tailgate Lock

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work with your Leer Tonneau Cover on your 2012 GMC Sierra. This is actually the exact same part number as the product in your photo so it is a…

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

I checked with Pop & Lock for you and there is a system that they have confirmed will work with 2011 and newer Leer 100XL, Leer 100XQ, and Leer 700: - Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau…

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #PE44CV can be found as part #311-BL-1120 on our site. This plugs into the harness at the canister and then you route and install the switch wherever it works best for…

Hey Shawn, yes the Air Lift Single Needle Gauge Panel part #AL26161 does have a light built into it. The spade connectors on the back of the gauge you'd run to the running light circuit which will light up when headlights are on.

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along with…

Pop and Lock does have the manual locking tailgate handle, #PAL5500, that will work with your 2015 Toyota Tacoma with backup camera. You can turn it into a power locking handle by adding conversion kit #PAL8525.

Your 2019 Ford F-350's Upfitter Switches can be used instead of the toggle switch for the Manual Switch Kit for Pace Edwards Bedlocker or UltraGroove Electric Tonneau Cover #311-BL-1120. The Manual Switch Kit #311-BL-1120 will work with the…

So long as you have the Leer 100XC truck cap, the correct Pop & Lock is the following: - Pop & Lock Power Lock Conversion Kit #PAL9772 I verified this with the manufacturer for you.

According to Pop & Lock, the #PAL9772 should work on a Leer 700 truck topper with the existing handle. If for some reason the handle isn't working, you can swap out to a new handle that will work with your Pop & Lock system…

I have linked the installation instructions for the Pop & Lock Custom Tailgate Lock with Plug & Play T-Harness #PL34FR below. You will want to see page 7 to locate where the plug and play harness ties into the factory wiring behind…

For your 2023 Ford F-250 I recommend the B&W Companion Slider #BWRVK3370. It uses a 1" thick dual jaw that wraps around the king pin for a tight, sturdy connection. This helps keep rattle down and makes hookup easier. Another great…