2015 Roadtrek SS-Agile Motorhome Spare Tire Cover

It sounds like the 2022 Chevy Silverado 3500 you are getting has the short bed. In that case, yes, you definitely want the sliding 5th wheel hitch for clearance. The good news is you will not need to purchase the entire…

In order to replace the Advent Analog Wall Thermostat ACTH11 you'll need the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air…

For a pair of stabilizer jacks that would have more than enough capacity that would work well on your R-Pod I would recommend the Stromberg Carlson Trailer Scissor Jacks part #JSC-24. These have a 5k capacity per jack and would do a great job as…

The power circuit for each leg of the Lippert Ground Control leveling system #LC358590 is protected by a 35 amp fuse. That means that at most the entire unit could draw up to 140 amps at a time. Realistically it would probably be considerably less…

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

I trust regular axles with leaf spring suspension more than torsion axles only because I can see what is going on with the suspension and can fix any issues should they arise. With a torsion axle though there really…

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

Yep, you're exactly right; the distance from the center of the hitch pin hole to the welded gusset is indeed four inches on the Curt Ball Mount for…

The biggest difference between the Tow Ready Tail Light Isolating Diode System #TR118821 and the Roadmaster Universal Hy-Power Diode Wiring Kit #RM-154 is that Tow Ready created their wiring kit with quick disconnects so if you ever get a new…

You will want to cut the yellow and green wires and connect the ends with a yellow butt connector. Then attach a small length of wire to both butt connectors and attach the wires to the input of the diode with spade connectors and then attach the…

If your step motor marked "REP 851" and the Part Number sticker says…

It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots…