Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
When lubricating your Titan Model 6 the Titan Zinc-Plated Brake Actuator part #T43397007K I recommend using a white lithium grease like LubriMatic White Lithium Grease part #L11354. It will give you great protection and lubrication. You will want to…
view full answer...The torque requirements for leaf spring u-bolts depend on the diameter of the u-bolts that are being used. If the gross weight of your tandem axle trailer is 7,000 lbs, then you likely have two 3,500 lb axles. Typically 1/2 inch diameter u-bolts are…
view full answer...Based on your description and measurements, this pair of fenders will make a great replacement. Typically you want to match the dimensions of your old fenders so at 60" long these will work well. They are also 9" wide and 12" tall.…
view full answer...The UFP 34044 is basically the Dexter DX7.5L A-60 part #DX89FR. The second number you mentioned is actually a phone number. But the #DX89FR would be an exact replacement for what you have.
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...If your 2011 Tundra has the factory 7-way trailer connector you I recommend the Hopkins Plug-In Simple Vehicle Wiring Harness, part #HM11143395. You would just need to unplug the old connector and install the #HM11143395. When working with electrical…
view full answer...You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…
view full answer...No, it does not matter which wire you use for the ground and which is used for power when wiring electric brakes. Each can be used for either purpose.
view full answer...The Curt SecureLatch Lunette Ring with 8-Position Adjustable Channel #CU49FR does come with the hardware needed to attach the lunette ring to the channel. It is 3 bolts, 3 nuts and 6 washers. The picture below shows every piece you would receive. If…
view full answer...While grade 8 bolts like you have are recommended to install a class 3 trailer hitch, I do not recommend using the bolts in your picture. For a trailer hitch like the Curt #14001 you were looking at, it uses 1/2" x 13 grade 8 bolts. Hitch…
view full answer...Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
view full answer...Is there a solenoid screwed in to the back of the master cylinder on the trailer? Or is there a lever on the actuator that you move whenever you need to be able to back the trailer up? If so, then you have a reverse lock out. I attached a link to a…
view full answer...Filters
2704 results
Vehicle Fit
Fit 2024 Tesla Model 3