Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I went out to our warehouse to take a look at the B&W Tow & Stow 3-Ball Mount #BWTS20048B and measured a distance of right at 5-1/2 inches from the bottom of the shank to the lowest point of the vertical adjustment post. I have attached an…
view full answer...The left and right ramps springs #RS16933LH and #RS16933RH install on a shaft of 1-1/2-inches diameter. The width of the coil is 2-1/2-inches and the overall length of each spring is 11-inches. You can refer to the linked videos and to the linked…
view full answer...In regards to the B&W Tow & Stow 3-Ball Mount part #BWTS10048B for 5" or part #BWTS10049B for 7", the distance from the top of the shank to the bottom of the upright while the hitch balls are stowed away is 8.5" for the 5"…
view full answer...I went out to our warehouse to take a look at the B&W Tow & Stow 3-Ball Mount #BWTS20049B referenced in your question. I measured a total length of right at 11 inches of the vertical adjustment shank on the ball mount. I have attached a short…
view full answer...Thank you for the photo of your horse trailer's oval clearance light lens. The lens markings are actually DOT references (not part numbers) but we can still help. Light part numbers are usually found on the base portion, not the lens, as shown on…
view full answer...I reached out to Pro Series and unfortunately there is no replacement parts available for the Pro Series Round, A-Frame Jack - Topwind - 15" Lift - 5,000 lbs #PS1400600303 you have so your only option will be to replace the jack. A frame jacks…
view full answer...First you are going to want to disassemble one of your hubs to verify if you have the #42 Spindle #TRU37FR. I have found this is the spindle some have found but you will need to determine it is what you have and if not you will need to have a pair of…
view full answer...You are exactly right when you mentioned an overall diameter on your ST225/75R15 tire of just under 28.3 inches. With this size tire, I recommend going with a 29 inch cover like the Adco Ultra Tyre Guard RV Wheel Covers - Black #290-3973. These…
view full answer...The closest option we have to the Command electronics Model 001-1050/1051 is the Gustafson RV LED Puck Light item #277-000489. It measures 4-3/8" diameter so the light is going to be slightly smaller 1/8" than your previous lights. I…
view full answer...It sounds like you likely have an A-Frame trailer, so you can use something like the etrailer Round, A-Frame Jack - Sidewind - 15" Lift - 5,000 lbs #TJA-5000S-B which will attach to the 3 mounting points on the trailer tongue and provide you…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…
view full answer...I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…
view full answer...Filter Your Search
Contact and Help