Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Bill, thank you for patience as I checked into this. I reached out to my contact at Curt and for whatever reason they don't know - they didn't even know this was something we carry aftermarket. Since it doesn't sound like Curt is…
view full answer...Between 4 and 6 inches is typically what is recommended as minimum clearance from trailer overhang to bed rails. If you can level your setup by lowering hitch where you'd have 5 inches you should be fine. Especially if you aren't in an area…
view full answer...I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…
view full answer...If you are unable to contact your trailer's manufacturer with your VIN to find the factory pin box model number there are some steps you can take which will allow you to determine what pin box model you have so you can purchase a new FlexAir. To…
view full answer...You should only need to add or remove air from the TrailAir pin box #LC158778 to get the lower portion of the upper collar on the shock lined up with the arrows on the lower part of the shock when under load. Take a look at the picture I provided to…
view full answer...The Trailair Air Ride 5th Wheel Pin Box - Lippert 1621 & 1621HD - 21,000lbs Item #LC158778 can have the air left in when not in use. The pressure will naturally decrease over time which is why the manufacturer recommends checking the pressure…
view full answer...If your Grand Design Momentum 397TH has the MORryde Cushioned 5th Wheel Pin Box, #MR24VR with a 1621 bolt pattern, yes the Trailair Air Ride 5th Wheel Pin Box, #LC158778 will match. This is a 21K rated pin box and has the same 1621 bolt pattern.
view full answer...The MORryde X-Factor Crossmember part #MR33WR attaches to the leaf spring hangers which are located in-between and in the front and rear of each axle. I have attached a photo below to clarify. Therefore, you'll need three for full support on a…
view full answer...In regards to a Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter like part #RP94720 and a Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Adapter Pin Box like part #325-GH-8045, the main difference is that one uses air for…
view full answer...If you are going to install two of the MORryde X-Factor Crossmembers #MR33WR on your tandem axle trailer Alan you would want to install them on the front and rear hangers. You can install a third one if you want on the middle hanger as well for even…
view full answer...The B&W Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches part #BWRVK2505 will work great with the Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57541 which are a fit for a 2020 Chevrolet Silverado 2500. Please note,…
view full answer...The Reese hitch you have will be compatible with ISR rails like the B&W #BWRVK2505. These custom-fit brackets are designed to work with factory holes in your Sierra's frame to make the installation easier and much faster. If you plan on…
view full answer...Filters
786 results
Vehicle Fit
Fit 2008 Acura TSX