Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Stephen! There are no direct adapters but we can pair two together to make this work. You can plug the Hopkins Plug-In Trailer Connector Adapter #HM54RV into your 4-way which will convert it to just the light functions on a 7-way. Then plug the…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...Hey Ivey, it sounds like you are looking for the Curt part #C35FR. This plugs into a 7-way which you should have at the rear of your 2025 Ram 1500 to give you a 4-way that has the resistors built in to allow the bulb out sensor issue to go away. You…
view full answer...If the outer diameter of your spindle where the seal rides is 1.719 inches and the diameter on your hub is 2.565 the #RG06-050 would be the closest matching grease seal we offer. You will need a digital or dial caliper for this measurement like…
view full answer...I do have options for you but there are no plug-in trailer wiring harnesses for a 2008 Mercedes-Benz GL450 unfortunately. The only way to install a trailer wiring harness would be to splice into the taillight circuits with the Hopkins Active Tail…
view full answer...Since we do not carry any rebuild kits for your Knott jack and I do not see any kits available online, I recommend switching to our Round Swivel Marine Jack #MJ-1200B. If this jack needs rebuilt we have the following common replacement parts.…
view full answer...Hey Bob, The B&W Digital Tongue Weight Scale #BW34KR still isn't out yet so we don't currently have that information. I reached out to B&W and they stated they don't have any info to release yet but that it should be on the market…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...I checked our inventory and it looks like we do not offer a hub with an outer bearing that will match the outer bearing dimension on your trailer spindle. That probably means you'll have a really hard time finding replacement parts, since we do…
view full answer...Sure can, as you will need the following mounting hardware for the 8,000 lb Dexter Electric Trailer Brake Kit #DX32QR: - Mounting Bolts and Hardware #BRKH122508 This hardware comes with the bolts and nuts to mount both brake assemblies.
view full answer...The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…
view full answer...Your best route is to replace your entire surge brake assembly as Atwood no longer produces any parts for their brake actuators. The Titan Zinc-Plated Brake Actuator #T47457207K is going to be your best replacement available. It is specific to disc…
view full answer...