Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Lippert Power Stance Electric Trailer Jack #LC89VR does not have a drop leg. The pin you see by the footplate is only for the footplate to remove and install it. The retraction and extension of the leg is electronically controlled. If you're…
view full answer...Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
view full answer...The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K would charge your lithium battery while still allowing you to charge the battery with solar power as well. The solar panels can be wire to…
view full answer...The stabilizer jack I recommend for your enclosed cargo trailer is the Drop Leg Stabilizer Jack #TJ01RT because it will work well to stabilize your trailer for loading and unloading and is easy to engage when needed. The #TJ01RT drop leg stabilizer…
view full answer...The Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware - Bolt-On - 2,000 lbs - Qty 4 Item #RR6K-4 comes with hex bolts like you can see in the attached picture. I was not able to find an reference from us to it coming with carriage bolts.
view full answer...To install the Stabilizer Jacks - 6-1/4" Drop Leg Travel #TJ01RT-HD you'll need to get 7/16" mounting hardware. In the attached review/installation video we use #14 self-tapping screws to mount these jacks into the frame of the trailer.…
view full answer...What's the condition of the battery on the trailer? It sounds like it has a weak charge on battery. Or just check the connections to the RV battery as well and make sure the terminals are tight as well.
view full answer...Yes it is super simple! The Complete Propane Tank Holder Mounting Kit for 20-lb Tanks part #37220BL is secured to the tongue of the trailer using self tapping screws. #14 self tappers have always worked out really well and they will go into the three…
view full answer...If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…
view full answer...To get both of the 2021 Subaru Outbacks pulling the Safari Condo F1743, you would need to purchase two of the #ETBC7 kits. They would piggy back off of the existing 4 pin connections already on the vehicles, so you are already partially there. I did…
view full answer...For your 20 lb tanks you want to use the kit #37220BL instead of part #37230BL that you referenced. The only difference between these kits is the length of the threaded rod that the hold down bar and wingnut attached to. The shorter one is used for…
view full answer...While tinned wiring is the norm when it comes to interior wiring on boats, boat trailers see a minimal amount of water compared to the actual boats. They do use a tin coating on the pins that are the parts of a wiring harness like the Wesbar 5-Pole…
view full answer...Related Searches
Filter Your Search
Contact and Help