Hey Rick, Do you have a 5-button thermostat or a 10-button thermostat? If you have a 5-button you'll either need to completely replace the entire system or the installation will require removing the controller from the previous units and…
All you would need to install your Prodigy P2 Brake Controller part #90885 in your 2014 Toyota Tundra would be the Wiring Harness part #3040-P. Check out the install video I attached that shows how this harness installs.
The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
The only thing I found on your Dexter 70-7 is the Replacement 13" Rotor for Dexter Disc Brakes #K71-631-00 which has 70-7 stamped on it. The #K71-631-00 fits 8,000 lb. Dexter disc brake kits like the #K71-646-2, #K71-646-2-91 or #K71-646-2-90.
The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…
You can still use the connector you have but you would need to move the red wire of the connector that plugs in to the vehicle to the opposite corner of the connector. Once you do that the brake controller will work just fine. I attached a picture…
It sounds as if you might have the wrong wiring adapter. The wiring adapter for the 2002 and 2003 Silverado will fit either vehicle, but the order in which the pins are wired is different. Therefore, if you have the incorrect one, it will still plug…
Hey Glen. We've got a couple of options for Optronics Smoke Series lights but we don't have the STL87DSRSHB which is a part number for a 10 pack. It looks like Optronics is phasing out the STL87 smoke series as well so I can't get them.…
For your application I recommend using the Titan Actuator #T63FR if you have drum brakes or the Dexter DX7.5 #099-175-20 if you have disc brakes. These are rated for 7,500 lbs and fit a 2" hitch ball which should match up just fine for your 2007…
I have attached a photo of a typical 4-way round connector with the pins labeled you can check out. The photo has both the trailer side and vehicle connectors labeled.
No, it does not. The bolt spacing on the Draw-Tite Front Hitch item #65075 is 33-1/2" wide, while the 2025 Frontier has 35-1/4" spacing on the frame, which is why this hitch will not fit. As of 5/16/25 there are no front hitches for the…
Filters
