Hello again Aaron, Congrats on the new 2026 Sierra Denali! What’s your new favorite feature? I know that you were looking at the Firestone air bags, but there isn’t a Firestone option that will work with the diesel engine. My top pick would be the…
If the shackles are flipping the wrong direction frequently that typically means the leaf springs are too short, the hanger spacing is too big, or the shackles are too short. Most of the time it's somebody changed leaf springs and just went with…
Hey Tony, with the Timbren kit part #T28MR that fits your 2024 Chevy Silverado 1500 that has a 2 inch lift you'd need a quantity of 4 of the 1 inch spacers part #A25723-90AH00 and you'd be set. Is it sagging when you are towing?
The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…
The Timbren Suspension Enhancement System #T28MR is the kit which will fit your 2024 GMC Sierra 1500. Do understand this is a very heavy duty spring with a weight capacity of 8,600lbs. This will most likely give you a less than desirable ride…
Electric brakes have 2 wires located at the back. One is for power and the other is for ground (it doesn't matter which is used for which function). The ground wires should be connected to the trailer frame. The only other place that would carry…
Before you can install a trailer brake controller in your 2022 Toyota Highlander you'll first need to make sure that you have a 4-pole wire harness for your lights installed and then a 7-way wire harness to get your brake function. If you…
If the SumoSprings #CSS-1168 is not picking up enough slack on your 2020 Ford Expedition, you can definitely add on to it. I spoke with SumoSprings and they said it is perfectly fine to add on another #CSS-1168 if the first one isn't getting all…
Yes, leaf springs must be replaced in pairs which is why one side left go and then the other shortly after. In regards to the stent you get on a full set of leaf springs, there are really a ton of variables present here so it is hard to predict.…
Hey Jim, Leaf spring ratings are listed as the axle's capacity which would mean that a pair of the #DX73CR would be rated for 2,800lbs. A single #DX73CR would only be rated for 1,400lbs. Since you have 3,500lb axles you'll need to make sure…
Hello Derek; unless the leaf springs you have now are worn out and flat you aren't going to be gaining any real height from other leaf springs. If your leaf springs run under the axle (underslung) you could move them to the top (overslung) using…
According to Dexter, the nut should be torqued to between 45-70 foot lbs. If you don't have a torque wrench close at hand, Tighten the bolts until the lock washer flattens, which will put you really close to the correct torque. We offer 4 nuts…
Filters
