It sounds like you are looking to add a second camera, so in order to do so you will need to add a Rear View Safety Multiplexer Box - 3 Channel #RVS-501N to switch between your cameras as I don't believe your system has multiple camera options.…
Hello Gilbert, thanks for reaching out. We do have brakes and hubs for Dexter 4,400 lb axles, but the sizing for these 4.4K axles can be funky depending when they were made. The best way to confirm what you need is with the casting number on the…
Hey Steve, to avoid having the trailer battery power the actuator of the Hydrastar kit part #HYD44VR you would want to install a diode that only allows the current to go to the battery and not from the battery back to the actuator. For that you'd…
Your bearing number combination is pretty rare but it actually matches 4,400 lb axle hubs like the Dexter part #8-407-5UC3-EZ. This will give you a hub/drum that has a 6 on 5-1/2 inch bolt pattern.
We only carry the Redline Wheel Rim Clamp #15-2 which is specifically made for the Dexter Axle Hub and Drum Assembly #8-174-5UC3. I suppose if you have different hub and drum assemblies then it is possible that they would use different clamps but…
The Dexter 8-222 model hubs currently on your trailer are designed primarily for mobile home use, and these types of hubs typically use unique bearing combinations that make it really difficult to find full replacement assemblies. Mobile home parts…
Hey Jeff, based on your axle info the correct bearing kit would be the part #BK3-310 for a kit that includes both bearings #LM67048 and #25580 as well as a grease seal. This would be all that you'd need as you can reuse the dust cover.
Thank you for providing the axle measurements. The only bearing that will fit the 1.375 inch inner diameter is the #LM48548 Trailer Hub Bearing. Unfortunately we do not have any hubs that are a fit with this bearing. Mobile home axles are often…
You do want to measure the springs with the weight off of them because they will flatten out with the weight added. Over time, springs can flatten a bit and that is why you are getting the 26 inch measurement. Based on the measurements you provided,…
So the short answer is no, there is nothing you can do to your current mounting plate to make another braking assembly fit your current setup. What you have is pretty unique, and when the team and myself took a look at it we were all in agreement…
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
The MORryde Wet Shoulder Bolt #MR52HR and Lippert Equa-Flex Wet Shoulder Bolt #LC126197 are identical in in size. The only difference I can see is the one comes from MORryde while the other comes from Lippert. Both have a length under head of…
Filters
