Are There Different Size Wheel Clamps # 15-2
Published 10/17/2018 >
Products Featured in This Question
Question:
are there more than one size clamp? I just purchased a well used trailer. It has two different axels. Both take 8-14.5 tires. It only had tires on the rear axel. I replaced the clamps and they seem fine. Tried to put on the other rims and the clamps seem too large.
asked by: Richard S
Expert Reply:
We only carry the Redline Wheel Rim Clamp # 15-2 which is specifically made for the Dexter Axle Hub and Drum Assembly # 8-174-5UC3.
I suppose if you have different hub and drum assemblies then it is possible that they would use different clamps but that would depend on their design.
Do your axles have the same weight rating or are they completely different? If this is the case then you really need to change them out so that they match. If they are different weight ratings then that means you likely use different hub and drum assemblies which would explain why the clamps only work with one assembly but not the other.
Product Page this Question was Asked From
Wheel Rim Clamp for Mobile Home Style Hubs
- Accessories and Parts
- Boat Trailer Wheels
- Golf Cart Tires and Wheels
- Trailer Tires and Wheels
- Rim Clamp
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: brake flange
- Search Results: leaf springs
- Search Results: trailer hubs and drums
- Search Results: trailer brakes
- Shop: Lippert Standard Dust Cap - 2.45" Diameter - Qty 2
- Search Results: trailer suspension parts
- Search Results: breaks
- Search Results: bed rack
- Shop: Lippert Trailer Axle Beam with Super Lube Spindles - 93" Long - 7,000 lbs
- Q&A: Looking For Brake Assemblies And Hubs For Dexter 4,400 lb EZ-Lube Axles
- Shop: Replacement Trailer Wheel Bearing - LM67048 - Qty 1
- Shop: 1-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/4" Long
- Shop: Kenda Karrier KR35 ST205/75R15 LRD Radial Trailer Tire w/ 15" Black Mod Wheel - 5 on 4-1/2
- Shop: Demco Trailer Brake Mounting Flange - 4 on 4-13/16" Bolt Pattern - 3" Pilot Hole
- Shop: Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Q&A: Trailer Hub that has Bearing Numbers LM67048 and L68149
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Shop: Brake Controller
- Video: Hands-On with the Trailer Brake Mounting Flange for 3-1/2" Axles, 12-1/4" Brake Assemblies
- Video: Review of Demco Trailer Brake Mounting Flange - DM52415
- Video: Easy Grease Trailer Hub and Drum Assembly for 5.2K & 6K Axles: The Breakdown
- Q&A: What Replacement Bearings Does Dexter 5,000 lb Axle
- Q&A: Hub for Mobile Home Axle With 1.375 and 1.25 Inch Inner Diameter Bearings
- Q&A: Can a Hayes 10 x 1 5/8" Braking Assembly W/ No Mounting Flange Be Converted to a Standard Flange
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes


