Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We actually have a spare wheel carrier for trailers with angle-iron rails with the etrailer Spare Tire Carrier for Trailer with Angle-Iron Railing #e99045.
view full answer...The Fulton Economy Spare Tire Carrier with Wheel Nut Lock #FETCSTL0701 would work just fine on a section of angle iron that is 3 inches by 2 inches. The frame does not have to completely fill out the U-bolt to allow the carrier to install. I…
view full answer...My contact at Dexter was able to use your Dexter Axle number 4389878 and Serial number 125263858 to find the bearings. She said your hub uses outer bearing 031-030-02, outer race 031-030-01, Inner bearing 031-019-02 and Inner race 031-019-01. These…
view full answer...I reached out to my contact at Dexter but they are having a hard time pinpointing the exact hubs your trailer is equipped with using the information you provided. The 8-286 number you mentioned actually refers to a 9,000 pound hub, which would…
view full answer...You have what is called a wishbone harness like #A20WB. This type of harness take the running light circuit and splits it at the trailer connector so that you do not have to run a jumper wire from one tail light to the other. The yellow/brown wire is…
view full answer...Yes, you can use a u-bolt spare tire carrier like the CE Smith Spare Tire Carrier for Trailers part #CE22011Z-11050-2 on a trailer that has an angle iron frame. I have attached a photo of a similar u-bolt spare tire carrier used on an angle iron…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...The difference in the Repair Kit for Fulton A-Frame Coupler 2-5/16" Ball with Wedge-Latch part #F640801 and the Repair Kit Fulton Wedge-Latch Cast Head Coupler part #F670801 is what couplers they fit. Part number F640801 is designed for use with…
view full answer...A solenoid that has 3 terminals total such as #PK5231201 grounds through the mounting hardware so it must be attached to a clean and corrosion free bare metal surface (if not otherwise internally grounded). A 4 terminal solenoid such as #PK5230701…
view full answer...The 235/80-16 sizes tires are the closest size that we have to your 9.5-16.5 tires. Your current tires should have a diameter of 30.6" and the 235/80-16 tires measure 30.9" in diameter. When it comes to clearance with your trailer you will…
view full answer...The spare tire can be mounted near the wheel and axle to the frame, but you will want more than 5 inches of ground clearance. I recommend the Extra Offset Trailer Spare Tire Carrier by Dutton-Lainson #DL22145 based on your photo. Every extra inch…
view full answer...The Fulton Economy Spare Tire Carrier with Wheel Nut Lock #FETCSTL0701 that you referenced would work just fine on a section of angle iron that is 2 inches by 2 inches. The frame does not have to completely fill out the U-bolt to allow the carrier to…
view full answer...Related Searches
Filter Your Search
Contact and Help