Result: command electronics trailer lights

The closest Go Power option to the Magnum Energy MM1212 Inverter Charger is the Go Power Industrial Pure Sine Wave Inverter Charger #34280055. This inverter/charger is rated for 2000 watts running and 4,000 watts surge/startup. This equals out to…

The Replacement Amber Lens for Peterson Oval Clearance and Side Marker Lights #108-15A looks to be a close match and it measures 3-3/4" long x 1-5/8" tall x 15/16" deep so it should work just fine.

Hello Michael, Congrats on the new 5th Wheel! What’s your favorite feature so far? Three words everyone likes to hear: "You are correct." And you are! Your pin box is indeed the Lippert Rhino. I’m not sure why Lippert doesn’t just put that…

The Curt Spectrum Brake Controller #C51170 should illuminate, even if the trailer is not connected. If you are getting no lights at all, this likely means the control unit is mis wired, or there is contamination in the trailer plug socket. We…

It sounds like the sensitivity needs to be adjusted on your Curt Spectrum #C51170 since it is too aggressive leading to the jumpy stop. To adjust the output and sensitivity you want to follow the instructions. This means you only make adjustments…

The LR Jack error code is identifying that there is an electrical issue with the left rear jack of your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590. You will need to check the fuse on the main controller for damage as…

Tom, unfortunately the controller 2020003067 is not going to work in place of the 289252, so It would need to be replaced with the 289252. I have also confirmed this with Lippert to make sure.

Hello Bill. The fact that the rear axle measures longer than the front is definitely concerning. Since both axles have the same part number and such, they should be identical in length. Trailer manufacturers do not make tandem axle trailers with two…

Hey Mark, thanks for all of the info you listed about your hub. With just that info we know that the hub/drum part #AKHD-655-35-EZ-K that you referenced is an exact replacement.

There would be no issue connecting the aluminum wires of the Hot-Line LED Third Brake Light #328-003-6017X to copper wiring. This draws such a low amount of amperage to operate that there would be no heat created.

Hey Joseph, the Stackers StayPut part #VAL33MB can work for you but you don't want to use them rotated like you mentioned. You just want to use them on the outside dually wheel like they were intended and you'd be just fine. You wouldn't…

Hello James, There may be one option that works for you, depending on the current cutout of your FIC lock, though I couldn't find any dimensions of a tall FIC lock. If your door is between 1-1/4" to 1-1/2" thick and the cutout for the…