Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Thomas, the RVIA code is that everything above the belly pan of the RV has to be copper until you reach the appliance. Rubber would be easier though wouldn't it?
view full answer...As you may have already found, 5200 lb, 6000 lb and 7000 lb axles can all use the same components including inner/outer bearings, hubs and brakes. Here are some other things they share in common: Dexter 5200 lb Regular Duty Axle - 0.180 inch tube…
view full answer...Looks like you have a round 4-way connector in the picture you submitted. The colors you mentioned aren't totally a match for standard colors but they are close. Normally the colors are: White - Ground Return Green - Right Turn and Brake Lights…
view full answer...Hey Mark, the distance between the mounting holes of the JR Products Magnetic Baggage Door Catch #JR64ZR is 4 inches.
view full answer...Your Hadco 3077 grease seal should have an outer diameter of 2.56 inches and an inner diameter close to 1.74 inches. Based on that the seal part #168255TB should be a fit. The outer diameter is 2.561 inches and the inner diameter is 1.687 inches. You…
view full answer...To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…
view full answer...I went out to our warehouse and measured the dimension of the Dexter Replacement Magnet for Dexter 12-1/4" Electric Brake Assemblies, #BP01-306. The magnet measured 4 inches long x 2-1/2 inches wide. This magnet is designed to replace the magnet…
view full answer...For a 12,000 lb Dexter axle the correct replacement brake magnets would be the part #BP01-306 which can work on either side of the trailer. Or for all new assemblies you'd want the part #23-442-443 which is one for each side. These come with…
view full answer...Good question. You are correct that the #A2252CB-GALV is 2-7/8" tall. When measuring an equalizer we will always go from center hole to center hole. The best way to measure the height is to first draw a line between the two lowermost holes, then…
view full answer...Hello Cody, we have just the thing. For the 1" diameter center bolt you can use part #7-136-2-6-112. The 3/4" leaf spring eye bolt is part #7-135-2.
view full answer...There's a rocker switch on the side of the 12-Volt Heater and Defroster #PTW5009 that you referenced that allows you to pick heat or fan. If you rock the switch towards the word "heat" it will put out heat and defrost your windshield.
view full answer...Heater #PTW5009 draws 13 amps at 12 volts which equals out to about 156 watts. I did a little research and from what I could find it is not ceramic.
view full answer...