Search: 6271   >  

If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is #HBA-10 and it has different wire colors, see picture. So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away…

The TDE 46245 you have is a Hub and Rotor for a 3500lb axle and uses inner bearing #L68149 and outer bearing #L44649 and uses the 5 on 4-1/2" bolt pattern For a replacement idler hub you can use the Trailer Idler Hub Assembly for 3,500-lb…

There are adapters available which will allow you to use Roadmaster tow bars with Blue Ox towing brackets. The Roadmaster Tow Bar to Blue Ox Brackets Adapter #RM-031 will work with Roadmaster's Blackhawk, Falcon, or Sterling tow bars with serial…

On the Tekonsha Prodigy P3 Brake Controller #90195 (great choice) the black wire is for 12V power, the blue wire is for brake output to the 7-Way connector, the red wire is for brake switch on the vehicle, and the white wire is for ground. Based on…

In the settings mode of the controller you can join the manifolds with the controller. To set the manifold into join mode locate the yellow join wire. It is the yellow wire with heat shrink on the end of it. Remove the cap leaving it attached to the…

Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

The size you listed isn't a standard trailer tire size so it makes me think that they are passenger vehicle tires which shouldn't ever be on a trailer. For a tire with a very close size that is rated for use on trailers I would recommend the…

I spoke with my contact at Pollak and he stated that the Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket, #PK11893-11933 is the correct replacement part for the Pollak PA66-MD40 that you have.

The wiring harness for your taillights located in the rear hatch is ran at the top of the vehicle under the headliner. Therefore, the easiest way to access the reverse light circuit would involve tapping into the wire loom at the top of the hatch…

We do carry some Lippert Hydraulic jacks but none by those part numbers. I tried looking them up on Lipperts site and found nothing on the 2571254 number and the 25712510 seems to have been superseded by a jack with a 14,000 lb. capacity, but not one…

I have a solution for you, however, the newly-updated Curt A-Series Fifth Wheel Hitches are NOT compatible with Reese Sidewinders, and they haven't been confirmed to fit other rotating pin boxes either. For this reason, I recommend to a Curt…