Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
view full answer...The closest leaf spring set we have available to the 22-1/4 inch length you mentioned is the 3-Leaf Double-Eye Spring #SP-113275. This double-eye leaf spring features a length of 23-1/2 inches from the center of the spring eye to the center of the…
view full answer...From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…
view full answer...I took a look at the online version of the owner's manual for your 2011 Ram 2500 and found a couple of fuses you will want to check inside the power module located in the engine compartment. There should be a 40 amp green fuse located in the J01…
view full answer...Hey Michael, the install of the etrailer base plate kit part #e96GV does require moving the adaptive cruise control bracket in most situations. That is still true so it would be likely you'd need to move yours on a 25 Maverick Lariat.
view full answer...The Kenda Karrier S-Trail #AM31199DX are going to be a more basic, white spoke wheel which is just going to give basic rust protection. An aluminum wheel that is going to provide you with the best rust protection possible, so I recommend going with…
view full answer...Hubs will heat up when driving, but if it feels like they are getting too hot, then you will want to look at a few things on your hub. My guess is that the spindle nut is too tight and the added stress on the bearings is overheating the bearings and…
view full answer...We may have a grease seal that will work in your application however, my research had conflicting measurements for the Hadco 3122 that you referenced. I contacted my technical contact at Redline to verify that the Redline Grease Seal #1105-100-031…
view full answer...Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…
view full answer...First, it does sound like, based on the measurement and information you have provided, that race #L68110, is correct since its outer diameter is 2.327 inches. This race is associated with bearing #L68149 which has an inner diameter of 1.378 inches…
view full answer...Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…
view full answer...That is not a dumb question at all; this is not a very common situation. I do have a solution for you, but unfortunately the Malone AirFlow2 Roof Rack #MPG215 and Malone AirFlow2 Roof Rack #MPG216 will not fit your 2020 Jeep Cherokee because the…
view full answer...