Fuse Locations for Trailer Running Lights on 2011 Ram 2500
Updated 04/14/2024 | Published 07/10/2018
Question:
2011 ram 2500 running trailer lights I just read the response to a previous question on this thread and Im hoping you might be able to tell me where I would find the relay for the running lights?
asked by: AJ
Expert Reply:
I took a look at the online version of the owner's manual for your 2011 Ram 2500 and found a couple of fuses you will want to check inside the power module located in the engine compartment. There should be a 40 amp green fuse located in the J01 position and a 20 amp blue fuse in the J14 position. Both of these fuses are related to trailer lights so you will want to check to make sure they are present and in good condition.
If the fuses are good and you are having issues with the trailer running lights, please let me know and we can continue to troubleshoot other possible causes.
Keith
3/1/2024
This information was 100% spot on to solve my issue of not getting 12v at the 7 pin connector on my 2012 Ram 2500. The 40a fuse at J1 was blown due to the body shop f***ing up my trailer wiring harness when they replaced the driver's side bed side. Thanks!!!
Mike L.
3/2/2024
Juan
4/14/2024
I try but no power to the hitch plug , I found out there is 3 fuse dead The turn signals lights work and the brake lights work but no power for running lights
Continue Researching
- Search Results: fuses
- Search Results: cartridge fuses automotive tools
- Search Results: break away cable
- Shop: Replacement Power Switch for Lippert Components High-Speed Power Stabilizer Jack - White
- Shop: JR Products Compact Automatic Changeover 2-Stage Propane Regulator
- Shop: Bigfoot Hydraulic Trailer Jack - Single Pump - Manual Override - 24" Lift - 8,000 lbs
- Shop: CE Smith Carpeted Bunk Boards for Boat Trailers - 2' Long - 1 Pair
- Shop: 12V Momentary Switch with Faceplate - On/Off/On - DPDT - White
- Shop: Replacement Control Switch for Lippert Hydraulic Landing Gear - White
- Shop: Empire Faucets RV Kitchen Faucet w/ Pull-Down Spout - Dual Teacup Handle - Brushed Nickel
- Q&A: Replacement Section for 7300 Series Distribution Panel 7345B
- Search Results: shocker
- Search Results: 89~3
- Shop: Fifth Wheel Hitch
- Search Results: 5th wheel hitch rails
- Shop: Gooseneck Hitch
- Video: B and W 5th Wheel Base Rail Kit Installation - 2015 Ford F-250 Super Duty
- Q&A: What is the Location of the Towing Circuit Fuses on 2011 Dodge Ram
- Search Results: enclosed trailer vent
- Video: A Closer Look at the Curt Custom Fifth Wheel Installation Kit for Ford F250 and F350
- Video: What to Know About the Curt Custom Fifth Wheel Installation Kit for Ford
- Shop: Trailer Hitch
- Q&A: Locations of 12V Power and Trailer Lighting Fuses in 2012 Dodge Ram
- Q&A: Troubleshooting 2011 Dodge Ram No Running Lights on Trailer, Brakes and Turn Signals OK
- Video: The Low-Down on the Curt Spyder Gooseneck Trailer Hitch for Fifth Wheel Rails
- Video: Ultimate Overview of the Curt PowerRide 5th Wheel Trailer Hitch
- Q&A: Trailer Running Light Fuse Location on a 2012 Dodge Ram 3500
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
Rob C.
7/16/2020
Chris R. Thank you so very much! I also have a 2011 Ram 2500. I rented a U-Haul trailer tonight and once it got dark noticed that the running lights were not working. I found your message as well as the burned-out 20 amp J14 fuse within a few minutes. I swapped out a 20 amp fuse from a circuit that I wouldn’t need tonight and I’m on my way again. Thanks again – you’re a lifesaver!