1998  x   >   1964  x   >  

the c terminal is for the switchboard, which is what? the m terminal is what the motor goes to. The b is terminal is for fuse and power supply? What if I do not have switchboard wire | For the Replacement 3-Speed Switch for Fan-Tastic Vent...

Can you flat tow a 1998 Subaru legacy outback AWD with manual 5 speed? Thanks Pierrre 4254663014 | Hey Pierre, while technically yes they can be flat towed, I really cannot recommend flat towing a 1998 Subaru Outback Legacy AWD manual 5-speed,...

will this bumper fit a 1998 ford f150 4x4 truck | We have a couple Westin bumpers that fit your 1998 Ford F-150 but part # 31016 fits certain model years of the Dodge Dakota and not your truck. Instead we have part # 31002 which is chrome plated...

Just picked up a new trailer 2013, Hooked it to my 1998 E350, with towing package. Rear plug is a 7 prong, with Ford markings. I think it came from the factory. I get no light on Voyager, and no braking, either manual slide bar, or...

I have a 1998 Jeep Grand Cherokee, Which I thought I bought new, with a Tow Package. The vehicle was used to tow a boat about 5K and the boat had surge brakes. The Jeep has 64K miles, always maintained 5.2V-8. I now intend to tow a trailer,...

Hi, I need to adapt a round 4 pin connector female with round pins on a Motorhome to 7 pin connector so I can hook up a tow dolly with brakes. Do you have anything that will work? Thanks. | I'd recommend you use our Brake Controller Installation...

Could you tell me where to find the brake pedal wire on a 1998 chevy 1 ton truck. Can not find wire to tie in with the red line. Thanks | Usually, on Chevy and GMC vehicles like your 1998 Chevy Pickup, the brake wire that carries the signal...

tHE CAR SIDE OF THE QUICK HITCH . MY QUSETION IS DOES THE CAR SIDE JUST BOLT TO THE JEEP BUMPER OFF OF THE JEEP FRAME | The car side quick disconnects are bolted directly to the base plates installed on the frame of your vehicle, and are then...

I was wondering if there are any issues that I would run into if I swapped the male 7 way plug on the trailer side to a female end so that I could have a removable double male wire between the car and trailer. I just want to clean up the look...

I have a1998 Chevrolet K-2500 8500 GVW with a BandW turnball gooseneck hitch. Would like to install air bag helper springs. Any idea what kit I need. The closes I can find is Firestone F2025. | We do have some rear suspension enhancement that...

I want to connect a 7 pin to my 98 Ford Expedition. I found the connector under the dash, next to the computer diagnostic port. Where underneath the rear of the vehicle would I find the connection for the 7 pin? Thanks | There are three different...

i just purchased a 1987 21ft sunline camper. TW 350 lbs, dry3040, gtw4400lbs.what do you recommend for weight dist and sway control. 1998 ford f150 4.6 V8.Do you also recommend a bigger trans cooler than the little 2 coil thats on the truck....

Can I make the side marker ligh blink when the turn signal is on? | If you want to make a side marker light blink with the turn signal it will have to be tapped into the turn signal/brake light wire for that side. But then it will also come...

I have 1998 Honda Civic EX and am contemplating purchasing the Swagman XC S64650 along with the dra tite 24677 and anti rattle lock S64029. I have had it with the trunk strapped bike racks as they tend to move their positioning. are these...

I have 98 chrysler Concord what do you sugest ? | For your 1998 Chrysler Concorde I recommend the Thule Passage trunk mount bike rack. The Passage comes in a 2 bike carrier # TH910XT and a 3 bike carrier # TH911XT. It features anti-sway cradles...

Will this fan fit my 1964 Chevy impala | While we do have a similar model that does fit, the Flex-A-Lite 15" # FLX168 does not fit your 1964 Chevy Impala. This is because the # FLX168 is only designed to fit certain models of Jeep CJ-5s and...

the hitch that is said to be an exact fit for my truck doesnt look like it will fit. The OEM hitch currently installed on my truck has mounting flanges that extend several inches vertically and attach to the top of the frame. Resulting in the...

Do you have a front mount 2 hitch that could work on a 1998 Astro van I am very interested in mounting a snow plow. SnowBear ProShovel Actuator Snow Plow | I have an option for you, but there is not a custom fit front mount trailer hitch receiver...

I am looking for 15 5 lug wheels for my haulmark 24 ft trailer. Do you sell any american made wheels Thank you. | We do offer 15 inch, 5-lug trailer wheels that are made in the USA, and you can choose from the exact color and style you want....

I have a Reese 20000 lb 5th wheel hitch I purchased used, I cant read the model #, but it has a 2009 date on it,would like any and all help you can give. 1998,Chevrolet C3500 crewcab,single rear wheel,longbox,2 wheel drive,,,,thanks much | We...

All the wiring diagrams only deal with the 4 wires for lighting. In addition, I need to run power to my vehicle to unlock the steering as well as the brake signal. How many wires are in the cable? 4? 6? Cable connector mount, vehicle...

I have what I think is a snow bear plow. It has the round pin hook up sockets at 31 apart on center -there are 2 square attachment pieces also. I can send pics. what is the correct front hitch adapter? | We offer SnowBear plows and mounting...

will this work on an 1998 Nissan Pathfinder??? | The Class III hitch for your 1998 Nissan Pathfinder would be the Curt Class 3 2-Inch Hitch, part # 13088. I am including a link to the installation instructions on this hitch. The Draw-Tite Class...

I have a 1998 4 runner and i ordered Curt hitch part # 13157. I somehow lost the installation instruction. Is there an online reference? If not can you mail one to me? Thanks | I have confirmed that the Curt # 13157 is indeed a fit for...