Result: knobs

For a 7-way and brake controller you will want the Installation Kit # ETBC7 and I would recommend the Redarc Liberty Trailer Brake Controller # RED52VR as it only has a small dash mounted control knob. The installation kit contains all the wiring needed to install the brake controller and your 4-way will plug into the wiring on the 7-way. |

With that being said my current favorite controller is the Redarc Tow-Pro Elite # 3RED44FR because it is a simple design that uses lights to communicate instead of codes, plus you only have to interact with a single control knob that can be installed virtually anywhere. To complete the installation you'll need the pigtail # 3040-P with the adapter # 331-TPH-017 which will plug into your factory brake controller port and the controller, and then you can use the Mounting Panel # 331-TPSI-007 if you'd like to place it in the switch panel on your Tacoma. |

Plus instead of having to mount a big brake controller you would only have a small knob you'd mount on the dash. | Hi experts - Were looking to purchase a travel trailer to pull with my 2015 F-150 XLT. I already have a Class...

Another feature that the Yakima has that the Thule does not have is the integrated knob which locks the Yakima carrier to the receiver. | I have a 2019 Honda Passport with a newly installed DrawTite hitch 76290. I have been...

Is the pin of the Thule T2 Pro XTR bike rack long enough to go through into the reducer sleeve so that when tightening the knob on the bike rack it will secure the reducer sleeve inside the main 2.5 receiver opening, thus preventing the reducer sleeve along with the rack itselve from sliding out of the 2.5 inch receiver opening ? |

This brake controller comes with a small knob that can be mounted to the dash for a factory look. | Hello! I have a 2023 Toyota Rav4 Hybrid XSE. I am looking to tow smaller trailers equipped with electric brakes. So, I need...

You'll want to turn the knob on the left side of the unit to bring the power up before setting the boost up, so it might have just been an error during the setup of the unit. | I have a prodigy P2 break controller in my Freightliner...

Checking the controller would be next, you should have power in to the controller on the black wire and power leaving the controller on the blue wire when the brake pedal is pressed or the manual slide knob is activated. The red wire should have power on it only when the brake pedal is pressed. |

Lock the pin and then tighten the Sherpa's anti-rattle knob to finish securing the bike rack in the hitch. | I am considering a C13068 for my 2015 Honda Odyssey. Its primary purpose will be for this 2 inch receiver Kuat Sherpa...

You will also want the Replacement Nylon Insert for TracRac Sliding Ladder Rack Modular Base Sliders # TAFX-42008 and knob # TAKB-90030-1. Then you would mount the complete roof rack system to these bases. | I am looking...

Just turn the oversized ratcheting knobs to secure this to the back of your GTI. | I just purchased a 2015 VW GTI and I am looking for a way to transport a couple bicycles. I think my best option is a hitch mounted bike carrier....

I would like to upgrade the hitch of course, install a brake controller that only has the rotary knob showing on the dash, and a 7 pin and 4 pin connector. | Hello everyone! I have a 2018 Chevy Express 3500. 6.0. I need to...

I have looked at Hitch C13172, Rack 63124, Locking Knob with Bolt SR0018. What am I not including and any other suggestions. | I am interested in a bike rack for my 2014 Jeep Cherokee. I like the idea of trailer hitch and...

On another note, in my testing, if I connect a test light to the brake circuit wire and ground, the controller works perfectly....activating the brakes when I press the pedal, or manually with the knob......Remove the test light and I am back to square 1, power output to the trailer brakes...... |

You will install the control knob in your desired location and that is the only visible part of the controller. | Good morning, We are asked to set up a hitch install for a 2014 Subaru Cross Trex XV non-hybrid. They like Curt...

On the Thule Helium Aero, # TH9042PRO, it measures 14-3/8 inches from the center of the hitch pin hole to the back of the upright mast, 11-1/4 inches to the lever that allows the rack to tilt, and 4-1/2 inches to the anti-rattle knob. Because the rear bumper curves up above the hitch, there will be no interference if you use the Helium Aero. |

The Liberty has a unique installation method where the main unit is concealed behind your dash and the only part visible is the control knob. You will need the Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item # RED69FR to complete the installation. |

The brake controller also needs to be mounted within the range specified in the instructions and not tilted or turned to the side. The leveler knob on the left side of the controller will also need to be in the proper position (straight up and down). |

There is a control box that gets installed under the dash, out of sight and then a control knob that gets mounted on your dash wherever you prefer. | Just purchased a Ford Ranger. The bumper will be higher than my old Ford...

The Liberty has a unique installation method where the main unit is concealed behind your dash and the only part visible is the control knob. You will need the Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item # RED69FR to complete the installation, since your Toyota does not have a plug in adapter. |

The reason the Tow-Pro Liberty is the best option is because of its unique installation method where the only visible portion is the control knob that's about the size of a nickel. The main unit is hidden away inside your dash to be completely out of the way and out of sight. |

The on-demand hot water and ability to set the temperature to a specific degree instead of the old fashioned arrow knob will make camping much more enjoyable. The # FR98SR has the following requirements to properly operate: 12VDC Power Input. 7.2-65PSI water Pressure (40-50PSI recommended). |

The main unit mounts behind the dash so only the control knob is visible. If you're using the Tekonsha wiring harness to add a 7-way you can plug it into that wiring using the # 331-TPH-017. | I have a 2020 ford transit 350...

If this does not resolve the issue, or it seems like the locking knob that is used to tighten the connection simply isn't doing anything, please let me know and I will be happy to look into this further. | I bought the carrier...