Search: trailer equalizer > RV Leveling Blocks >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Thanks for reaching out Chris, I'd be happy to help. The Lippert Road Armor Equalizer Kit #LC53CK includes the two equalizers with the bronze bushings pre-installed. To complete the setup, shakles/wet bolts are in the Dexter Heavy-Duty Suspension…
view full answer...Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…
view full answer...Hey Mark! Assuming they are 25-1/4" leaf springs I recommend the 3-Leaf Double-Eye Spring for 4,000-lb Trailer Axles #e57SR. These are our in house brand and will save you some money. If you would prefer to stick with Dexter we also have the…
view full answer...Hey Greg, thanks for the information. To replace your equalizer you'll want the Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 6-1/4" Long - 3/4" Center Hole item #TREQ458. From the way you described yours this matches your…
view full answer...Hey August, welcome back. If your current springs are 25-1/4" long you'll want to replace them with the same size leaf spring. The 25-1/4" Long 3-Leaf Double-Eye Spring item #e57SR you were looking has a 2,000 lbs capacity and is…
view full answer...Hey Oakley, this is a great question and one that I've not had before. But yes you can use a hub/drum in place of an idler for a spare setup if needed. The hub/drums and the idler hubs are dimensionally the exact same in terms of the hub portion…
view full answer...The recommended distance between the hangers of the #APS1 would be 24-7/8 inches when using the leaf spring #e54SR. When the trailer is set on the ground and the leaf spring is supporting the weight of the trailer the spring will flatten out and get…
view full answer...The end of the Replacement Manual Crank Handle #LC119226 is a slotted cylinder which means there isn't a socket that would work as a substitute.
view full answer...You should have a standard 1/4" grease zerk fitting on your EZ Lube spindles. The 1/4" zerk is a fairly common size so you should be able to easily acquire one. We actually have the Powerbuilt Pistol Grip Grease Gun #ALL940798 which would…
view full answer...Given the fact that you've found that the suspension is in good repair with nothing bent or broken, the holes in the shackle straps not ovalled out, no knots or bulges in the tires and the tires are balanced there's not much remaining that…
view full answer...Assuming that your shackle links measure 2-1/4 inches center hole to center hole, the ideal replacement for your existing #A2252CB-GALV suspension equalizers would be the #K71-653-00 E-Z Flex kit from Dexter Axle which is good for axle capacities up…
view full answer...I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…
view full answer...Filters
- 13 results
Vehicle Fit
Filters
