Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The B&W Biker Bar Motorcycle Tie-Down System #BWMC2301 will be bolted to the toy hauler floor so to remove it you would have to un-bolt it from the floor every time you needed to move it. While not difficult to do, especially with power tools, it…
view full answer...The interior lights of your enclosed trailer are likely connected to the 12V (Auxiliary) power pin on the 7-Way of your trailer. You can verify this by applying 12V power from a separate battery to this pin and seeing if that supplies power to your…
view full answer...We've checked with B and W in the past and they have told us that the Biker Bar #BWMC2301 fits your 2018 Harley Davidson Tri-Glide.
view full answer...If you are looking at the front of the 7-Way connector the #4 terminal which is at the 1:00 position will be the 12 volt power connection. If you do not have power run to the #4 terminal on the 7-Way vehicle connector you will want to run a 10 gauge…
view full answer...Since the Furrion Vision S systems like #FCE48TASL-05 can support up to 4 cameras you can add an additional sharkfin camera part #FCN48TASF to what you have now.
view full answer...The working load limit for the E-Track system like the part #E19148 that you referenced is 2,000 lbs. There isn't a set method required for tightening a load to the E-Track. Basically you would want to use a properly rated strap for the weight of…
view full answer...If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…
view full answer...I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…
view full answer...The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…
view full answer...Related Searches
Filter Your Search
Contact and Help