Search: 2" hitch extension   >   Fifth Wheel Hitch   >  

On a single axle trailer you will want to have a hanger spacing of around 22-3/4 inches when using the 23-1/8 inch long Double-Eye Spring #e59SR. This will allow that rear shackle to correctly lean away from the axle for proper suspension travel.

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

The trick here is to get as close as possible. If you are talking about less than 2 inches or so, there is nothing to worry about. Having the trailer tongue a bit too high is preferable to it being too low. You may be a good candidate for an…

The Dometic 310 Part-Timer RV Toilet, #DOM37FR that you currently have, in tan, is a standard-height RV toilet with a ceramic bowl and slow-close lid. It is 20" tall with a seat length of 15-1/4" and seat cutout dimensions of 10-3/4"…

The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.

It cannot; here is what B&W states regarding using the Companion in the slide position (which they call the "maneuvering" position): "The maneuvering position is only intended for parking maneuvers and not for towing. Using the…

In order for the Yakima SweetRoll Kayak Carrier w/ Tie-Downs - Saddle Style - Rear Loading Item #Y04074 to fit, the crossbars you are securing them to must be no wider than 3-1/2" and no taller than 1-11/16". The Thule TracRac #TH27000XT…

The bearing that you have on the trailer hub measures just under 1 inch (0.985) and we are not going to have a hub that accepts a bearing with an inner diameter of that size. This is common for the trailer kits like the Haul Master branded trailers.…

The 30205 bearing that you referenced has an inner diameter of just under 1 inch (0.985 to be exact). We do not have this particular bearing or a hub that uses this size bearing available. The #L44643 bearing that you also mentioned has an inner…

You are correct that the spring seats included in an over/under conversion kit like the Dexter Trailer Springs Over-Under Kit #K71-384-00 should be tack welded on in most cases. I checked with one of my engineering contacts over at Dexter and he did…

You cannot use a weight distribution system with a pintle hitch. You would need to remove the pintle hitch you have now in order to use a weight distribution system. Once you do this, I recommend using the Equal-i-zer Weight Distribution System which…

Since you have a 2017 Armada the pre-wiring is on the right side of the steering column, above the accelerator (see pic). This is where you'll plug the part #3050-P into for the Prodigy P3 part #90195.