Replacement Hub, Drum and Brake Assemblies for AL KO 3,500 lb Axle
I have a 2008 Flagstaff camper with two Alko axles. It is in need of new brakes/drums. Ive attached a photo of the plate attached to the front axle. Could you reference me to the proper parts, drums and brakes, including seals and dust caps...
Recommended Replacement Hydraulic Pump Motor for a Lippert Leveling System
is the 172911 the replacement for 414850 on a Lippert leveling systems? | Tan, it actually looks like the Replacement Hydraulic Pump Motor for Lippert RV Leveling Systems # LC57AF is the correct replacement for your Lippert 414850. To get...
Troubleshooting Curt Trutrac System Digging Into Brackets
I recently purchased the Curt Trutrac WD C17501 for my 2004 Ford Excursion towing a 39ft travel trailer. The tongue weight loaded is around 1100 lb. The RV dealership installed the weight distribution on my trailer and set it up but after driving...
Recommended Air Bags for a 2005 Ford Econoline 350 w/ a V10
I have a 2005 Ford Econoline 350 with V10. It has a 3 inch lift. Do you have any rear air suspension products that would work with the lift. I want to tow with it and I am a huge fan of of the rear suspension airbag systems. | Hey Russell, we...
Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
What is Max Amperage Draw of Bulldog Winch Light Duty On-Board Air Compressor
What is the maximum amp draw of this compressor? | Hey Michael, the Bulldog Winch Light Duty On-Board Air Compressor # BDW46TJ draws at max just under 40 amps. |
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
What Rack System Can I Use On My 2002 Ford Excursion With Factory Side Tracks
Will this fit the factory tracks of a 2002 ford excursion? | Great question, Dave! After some double checking I can confirm that Rhino Rack part # Y02-480B-NT will work on the factory tracks on the roof of your 2002 Ford Excursion. What are...
Looking For A Shocker Hitch For My 2003 Ford Excursion Pulling A 7k Trailer
I am interested in a shocker hitch. I have a 2003 ford excursion, 7.3 l diesel with 4 wheel drive. I primarily pull a RV that weighs 7,000 lbs. What model do you recommend? thanks | Hey Patrick, The Shocker Hitch # SHK47VR would be a solid...
Looking For Replacement Weather Stripping For Lift Gate On 2003 Ford Excursion
I need to replace the weather stripping for the lift gate on my 2003 Ford Excursion and the OEM Part 2C7Z-78404A06-AA has been discontinued. I have been searching junk yards and the internet for something that might work. Might you have something...
What To Do When The Air Lift Air Bag Helper Spring Fails During a RV Trip?
I have the 5000 Air Lift series bags on my 2WD Ford Excursion, and during the beginning of our three month RV trip the passenger side will not hold air. Troubleshooting my a local mechanic indicates bag is damaged. What recourse do I have while...
Troubleshooting Open Ground Warning on P3 with Known Solid Ground Connection
I have the Prodigy P3 installed on my 2003 Excursion 6.0L diesel using the 3035-P adapter. Intermittently I get the Open Ground No Brakes warning message. No trailer connected. I checked the batteries negative terminal to chassis in the engine...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Recommended Factory Replacement Hitch for a 2000 Ford Excursion
2000 Ford Excursion with towing package. The current Ford hitch has an electrical connection in a steel frame to the left of the hitch. I don't see that on the CURT 14011 Class 4 Trailer Hitch. Do I have to remove the current electrical connection...
Replacement Hardware for etrailer Hitch on 2010 Crown Vic
What replacement bolt kit do I need to purchase for a 2010 crown Victoria. | Hey Kevin! I'm assuming you have the etrailer # e66AR since that is what you were looking at. You will need the Replacement Hardware Kit for Trailer Hitches # RHK....
Trailer Wiring Harness for a 2003 Ford Crown Victoria
Need part number for trailer wiring harness. | For your 2003 Ford Crown Victoria you can use Hopkins trailer wiring harness # 46255. There isn't a T-connector that just plugs into the taillight wiring available for your vehicle so you will need...
Trailer Wiring Harness Kit For A 2011 Ford Crown Vicotria LX
Hello, I need a trailer wiring harness kit to plug in to my trailer. The trailer has a seven-pin plug, but I assume a four-pin flat with an adapter will work well enough. The car is a Ford Crown Victoria LX 2011. I am confused by the many...
Looking for Replacement Locking End Caps for Rhino Rack Aero Roof Rack
hi- i am wondering if rhino rack locking end cap part m622 is available to purchase and what size security key is used to operate. thank you in advance for your time. chris baer | Hey Christopher, it sounds like you are looking for a replacement...
Air Bag and Auto Leveling Compressor kit for 2003 Ford Excursion
Hi. I would like to install air bags on my Excurion 2003 4wd diesel. I would like it to auto level and not have to mess with bicycle pumps etc. Is there a kit for that? Thanks | Hey Pete, we have just what you are looking for with the Firestone...
Best Way To Test Trailer Side 7-Way Without A 7-Way On Tow Vehicle
Hello, I have a 1974 apache pop up trailer and I am currently trying to retrofit the original trailer plug harness from the rectangular 6 way plug it came with to a modern 7 way plug. I have all my wiring connected per the diagrams that I have...
Recommended Trailer Hitch and Weight Distribution System for 2004 Ford Crown Victoria
Please direct me to info on changing my stock 2004 Crown Vic to pull a large trailer and a loaded car with a total of about 4500 pounds. I understand a Police Interceptor would be better suited for this. Thank you | For your 2004 Ford Crown...
How Many Catalytic Converters are on a 2007 Ford Crown Victoria 4.6L V8
what do i need to buy? two converters? do i replace sensors? | The 4.6L V8 engine in your 2007 Ford Crown Victoria uses two catalytic converters. There is one converter coming from each side of the exhaust manifold so you would need two of MagnaFlow...
Replacement Keys For Rhino Rack
I purchased a Rhino roof rack system 2003 Ford Excursion from you 3 or so years ago. Im in need of replacement keys, the lock number is 012 and the rack end cap is code M622 original keyinch was a blue plastic round key. Can I get those from...
Which Should be Set Up First Air Bag Pressure or Weight Distribution
Hi, my name is Cliff. I just purchased the AL57132 from etrailer. I had it installed on a 2001 ford excursion. I have been using a weight distribution system for towing a travel trailer. Normally I would hook the truck up to the camper,...
Filter Your Search
Contact and Help