2013 Radiator Fan

Hey Trent, from what I found your 1995 Jeep Grand Cherokee uses an 18 inch diameter clutch fan like the part #D17118. The part number you referenced is 17 inches so it wouldn't work but I would recommend measuring to verify this.

Hey Bob, Landing gear components aren't all interchangeable between brands so I'd need to know the exact model to find replacement parts for your current system. If you're just wanting to replace the landing gear as a whole then I'll…

Hello Ernest, We are just here to help with any questions people have, regardless of if they bought the parts through us or not. Unfortunately, we no longer carry the knob for the V2, they have upgraded to the V3 model and we have sold out of all our…

Hi Bob! The Timbren #TGMRG25C you ordered will have 6,000 pounds of load assist and will be the highest rated option available for your 2003 Tahoe. This will definitely solve your sagging issue, especially if you are close to or at the maximum load…

Yes, there is a bolt that goes all the way through that holds the Timbren Rear Suspension Enhancement System item #TGMRG25C in place. I have linked the instructions and an installation video below so you can see the steps involved and all the tools…

Hey Ronald, the landing gear part #RVLG-8HDL does not come with new brackets but we have them available with the part #LG-Brackets. These will need to be welded on as there isn't a way to bolt on the jacks to the brackets you have now.

I have included some pictures of Curt Front Mount Trailer Hitch Skid Shield #C31007 for you. The overall height of the skid plate is 4-1/4 inches, overall width is 4-7/8 inches. The overall length of the unit end to end is approximately 8-3/8 inches.…

Both of the 2" receivers on the TorkLift SuperHitch Original Trailer Hitch Receiver - Custom Fit - Class V - Dual 2" Receivers #TLF1006 have the same tongue weight rating of 1700lbs and trailer weight rating of 17000lbs, Or 2000lb tongue…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The overall dimension you are measuring is the length of the outer tube of the jack. If you check out the first picture I attached you'll see where the part #LG-1 measures 29-1/2 inches in length. The second picture I attached shows the…

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

We do have motors that you can add to your landing gear. For example, the Landing Gear Set #RVLG-8000 can be operated with the manual crank #RVLG-HDL but you can also add the motor #LC142178 and switch #LG-145236 for effortless operation on your end.…