2013 Fender Flares

No, I am sorry as there isn't a base plate that I can guarantee would also fit with this grille guard. Often they will be using the same space or attach in the same places. What type of bumper does your Jeep have? I am happy to…

Hi Kerry; the 339894 is actually still an active part. The correct replacement motor is the Replacement Electric Motor Assembly for Lippert Coach RV Steps #LC63BX which is the same as the 339894.

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount -…

For a bumper mounted spare carrier that has capacity for an 80 lb setup we have the part #BR56VR from Brophy that fits a 4 inch bumper like you have and would work well.

Hi Dave, The etrailer Invisible Base Plate Kit #e98948 and Blue Ox Base Plate Kit #BLU53FR are designed slightly different, but both are compatible fits for your 2023 Jeep Gladiator. The #e98948 is going to be an easier installation since you…

Yes, it does. The arm on the Kuat Pivot 2 Swing Away Hitch Extender item #PVD20B locks at 90 degrees and opens up to 120 degrees. I have attached a photo below that shows how this function works.

Using a hitch extender is safe as long as you stay within the limits specified of 50 percent of the hitch and vehicle load capacity, and 350 lb tongue weight capacity of part #HE06. The other option to provide additional clearance from your spare…

If 380 pounds is the tongue weight of your trailer, then you are correct. You add the tongue weight of the trailer to bike rack and bikes, and that total is your total tongue weight. Make sure you are within the tongue weight capacities of both…

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948.…

Hi Richard! It sounds like you're needing to install the Load Resistor Kit for LED Turn Signals #DI34ZR on the turn signals you've installed on your toolbox. Since LEDs don't require as much power as incandescent…

Hey Dave, In my opinion the etrailer Invisible Base Plate Kit #e98948 is going to be the stronger option compared to the Blue Ox Base Plate Kit #BLU53FR. Blue Ox started adding safety cables to their baseplate kits as a last resort backup in the…