Radiator Fans Specs:
Features:
26-1/4" x 15-1/2" x 2-5/8". Dual S-blade, shrouded, 12V nylon puller fan with speed controller helps provide consistent cooling. Draws power from the electrical system, freeing the engine belt for improved performance and fuel economy.
More Information >Radiator Fans Specs:
Features:
26-1/4" x 15-1/2" x 2-5/8". Dual S-blade, shrouded, 12V nylon puller fan with speed controller helps provide consistent cooling. Draws power from the electrical system, freeing the engine belt for improved performance and fuel economy.
More Information >Radiator Fans Specs:
Features:
26-1/4" x 15-1/2" x 2-5/8". Dual S-blade, shrouded, 12V nylon puller fan with speed controller helps provide consistent cooling. Draws power from the electrical system, freeing the engine belt for improved performance and fuel economy.
More Information >Videos
for Radiator Fans
Help Articles
for Radiator Fans
Expert Answers
for Radiator Fans
Hi Bob! The Timbren #TGMRG25C you ordered will have 6,000 pounds of load assist and will be the highest rated option available for your 2003 Tahoe. This will definitely solve your sagging issue, especially if you are close to or at the maximum load…
view full answer...Yes, there is a bolt that goes all the way through that holds the Timbren Rear Suspension Enhancement System item #TGMRG25C in place. I have linked the instructions and an installation video below so you can see the steps involved and all the tools…
view full answer...Both of the 2" receivers on the TorkLift SuperHitch Original Trailer Hitch Receiver - Custom Fit - Class V - Dual 2" Receivers #TLF1006 have the same tongue weight rating of 1700lbs and trailer weight rating of 17000lbs, Or…
view full answer...For the best performance, a radiator fan like Derale 12 Inch High-Output, Electric Radiator Fan, #D16925, should be mounted directly against the radiator. If there is a gap, less airflow will go through the radiator and it will not be as efficient.…
view full answer...I have included some pictures of Curt Front Mount Trailer Hitch Skid Shield #C31007 for you. The overall height of the skid plate is 4-1/4 inches, overall width is 4-7/8 inches. The overall length of the unit end to end is approximately 8-3/8…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Yes, the Flex-a-lite Direct Fan Dual Electric Radiator Fan with Shroud #FLX284 can be used for towing applications on your 2004 Chevy Silverado with the 6.6L V8 diesel engine. Unfortunately, this fan (and all other fans) does not change the maximum…
view full answer...The Curt Front Mount Trailer Hitch Receiver #31320 will provide better ground clearance for your 2005 Dodge Ram 1500 by approximately 3 inches. I have attached a photo that will show you the measurements from the mounting surface of each hitch to…
view full answer...Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…
view full answer...For a safety chain that will be sufficient for most gooseneck trailers I really like the Fulton Safety Chain with Clevis Hook part #FCHA0050324. This safety chain has a grade 70 rating with large clevis hook. You will need two of them for your…
view full answer...The Flex-a-lite 16" LoBoy Electric Radiator Fan 2,500 CFM #FLX118 is the puller fan equivalent of the model #FLX119 you were looking at so if the 16" wide x 16-1/2" tall x 3-3/16" deep dimensions…
view full answer...