Dimensions of the Timbren Heavy-Duty Axle-Less Trailer Suspension # ASR2KHDS03

Question

Question:

Is there a complete detail dimension on this on this . I,m in integrate this into my pop-up camper. Fender wells are cannot be alter. so if dimensions on this part are available it would be a great help .Thanks

asked by: SAM

1

Helpful Expert Reply:

I attached a picture that has all of the dimensions for the Timbren Heavy-Duty Axle-Less Trailer Suspension # ASR2KHDS03 listed.

expert reply by: Jameson C

1

click to enlarge

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Lucas, It looks like both the Redarc #RED72CR and #RED68CR are going to include the same wire harness #RED99FR, but the #RED72CR is also going to include some mounting panels to make mounting the control knob into your dash easier so I'd go…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hey David! There's no difference other than the sale on the Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness -item #RED72CR or item #RED68CR. Both of these include the Tow-Pro Liberty and the plug and play adapter you'll need for…

view full answer...

Answer 8

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 9

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 10

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Norm, thanks for hanging out! Along with one fitting different brands of trucks the Trail and Elite are also different. The Tow Pro Trail # RED94UR is designed to be used primarily off-road, specifically engineered and tested for off-road adventures.…

view full answer...

Dimensions of the Timbren Heavy-Duty Axle-Less Trailer Suspension # ASR2KHDS03

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching