Grease Cap for a Concrete Mixer with Inner Diameter of 2.375
Published 10/24/2014
Products Featured in This Question
Question:
the dust cover has to be a press on vice-grip type with a OD of 2.375 inches and has a rubber seal. the picture shows the inside diameter of the shaft as 2.375 inches. Thanks
asked by: David H
0
Expert Reply:
The closest grease cap we offer to the dimension you listed that is designed for a trailer hub would be the # F001601, this is designed for a 2.333 inner diameter hub so it might be a little small. It is a press on style that does not have a rubber seal though.
Since this is designed for trailer hubs I can't safely guarantee that it would work for you.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Spindle Grease Seal Set for 25580 Inner Bearing and 2.441 Bearing Buddy
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 2.38 Inch I.D.
- 3.37 Inch O.D.
- Bearing Buddy
more information >
Continue Researching
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Is there a Replacement O-Ring that Sits at the Back of the Spindle Before the Backing Plate?
- Article: Most Popular Wheel Bearings
- Q&A: Is It Okay for Tires to Crack at Sidewall and Tread
- Q&A: Need 8-Lug Brake Drum For 2005 Keystone Montana
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing