How to Add a 7-Way Trailer Connector to a 2011 Honda Pilot

Question

Question:

I have a 2011 Pilot EX with the 2 inch receiver but no electrical connection on the back bumper. I have watched the installation video and I have observed both the grey connector on the interior compartment of the rear drivers side and the other connector underneath the rear drivers side rear bumper are both present on my vehicle.

asked by: Gary

0

Expert Reply:

The presence of the plugs on your 2011 Honda Pilot does not mean that they are active. The difference is in how the vehicle is equipped. If the 2011 Honda Pilot did not come with a factory installed 7-Way trailer connector, that means that it is not set up to accept just a 7-Way by itself. In that case, you would need # 118253.

expert reply by: Michael H

0

Answer 1

There are two tabs on either side of the cap, with the tabs released apply a rocking motion back and forth. You might have to keep at it for a bit, but the cap should come off. Avoid using brute force like pliers, if those tabs are damaged the plug…

view full answer...

Answer 2

It would appear that the 2006 Ridgeline either came with a factory installed 7-Way connector at the back or it didn't. If it isn't present then your model must not have come with it. But you can add one. To add a 7-Way you will first need to…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

How to Add a 7-Way Trailer Connector to a 2011 Honda Pilot

Continue Researching