How Tall Are The Kodiak XL ProLube Kit XLPROLUBE2440KIT Oil Caps?
Updated 10/14/2026 | Published 10/08/2026
Question:
I have a 2026 rock solid enclosed trailer with 5200 axles. I am interested in the oil bath hubs , I have ez lube now. I would like to know the dimensions of the xlprolube2440. I need to see if they will fit inside my hub covers on the aluminum wheel. Thanks.
asked by: Michael D
Expert Reply:
Hey Michael, thanks for reaching out. I went out to our warehouse and measured the caps included with the Kodiak XL ProLube Kit # XLPROLUBE2440KIT. The caps are approximately 2" tall overall including the cap and lid.
How much room do you have inside your hub covers?
(click to enlarge)
Michael D.
10/14/2026
Is that measurement from end to end or shoulder to end of the cap?
Jesse M.
10/14/2026
Product Page this Question was Asked From
Kodiak XL ProLube Kit for for 5,200-lb to 6,000-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 2.44 Inch
- 5200 lbs Axle
- 6000 lbs Axle
- Kodiak
more information >
Continue Researching
- Search Results: 8k drum
- Shop: Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- Shop: Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - Oil Bath
- Shop: Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2
- Q&A: Which Caliper Should Be Used With The Dexter 9-3/4" Hub-and-Rotor Assembly DX82UR?
- Q&A: Converting Standard 7K Grease Hubs to Oil Bath Hubs
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Q&A: Can Two Batteries Wired In Parallel Receive a Charge at the Same Time
- Q&A: Replacement Oil Bath Hub Body and Cap for a UFP Oil Bath Hub w/ a 1.98 Hub Bore
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Article: Trailer Wiring Diagrams
- Q&A: Disc Brake Kit that Fits 10k AL-KO Trailer Axles
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
Chris
10/13/2026
I've had great luck with these. I have a triple axle boat trailer and I upgraded the brakes and hubs and went with the oil, bath, bearings and seals and so far everything's working great. I've had a problem with one wheel in particular but it could be my problem. It keeps leaking but I think I've got it fixed now. Just be very careful about how you install the seals and the cap on the outside. I had to use a die grinder with the little wire mesh wheel to take off the dakra mat finish because everything was too tight. But other than that you're doing good