Removing Electric Brake System From Car Dolly and Replacing With a Surge Coupler and Disc Brakes

Updated 07/28/2014 | Published 07/25/2014

Products Featured in This Question

Dexter Premier Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs

(80)

$555.91

Dexter DX7.5 Drop-N-Go Brake Actuator - Disc Brakes - 2" Ball - Zinc Plated - 7,500 lbs

(106)

$381.95

Kodiak Hydraulic Brake Line Kit - Single Axle - 15'

(44)

$114.11

Replacement Trailer Wheel Bearing - L44649 - Qty 1

(2229)

$23.07

Replacement Trailer Wheel Bearing - L68149 - Qty 1

(2229)

$20.57

Grease Seal - Double Lip - I.D. 1.719" / O.D. 2.565" for 3.5K and 4.4K Axles - Qty 2

(2944)

$8.36

Question:

I have an American Car Dolly which has electic brakes. I want to switch to disc brakes with actuator in hitch and do away with electric control. Pulling a 2013 VW TDI behind a 2003 Holiday Rambler Neptune RV. Will these work?

asked by: George W

Expert Reply:

If the existing hubs on your dolly use a # L68149 inner and a # L44649 outer bearing and a 10-19 grease seal, the rotors will be compatible. You'll also need to make sure your existing wheels are at least 14 inches in diameter and have a 5 on 4-1/2 inch bolt pattern, the # T2HRCM10DAC hub/rotor assemblies you mentioned would work great.

So long story short, if the rotors are compatible with the spindles and wheels are compatible with the rotors, the Titan # T2HRCM10DAC kit will work well for you. You'd also need a surge actuator like part # 099-175-20 which is compatible with a 3 inch wide trailer tongue and a # 15SI-BLKIT brake line kit.