Hands-On with the etrailer Hub Bearing Kit Video

Linda yes, you are going to also need a hanger kit like the Tandem-Axle Trailer Hanger Kit for Double-Eye Springs #APT9 to install the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles #DX23CR you'll just need to let me know what size hangers…

Hey Greg, There unfortunately there isn't a guide to tell us the bearing and grease seal combination for your hub so you'll have to remove it and check the bearings/seal for their part numbers or use a digital caliper #PTW80157 to measure the…

If you know the brand and weight capacity of your axle, we should be able to figure out what bearings it uses and what hubs are compatible. If you do not have that information, the next best option is to use the bearing part numbers and the weight…

Grease seal set #RG06-050 is what you will need. These are double lip seals, just like what you have (the spring indicates that) and the dimensions are all the same including the 1/2 inch width.

I sure can Mark and thanks for the information! The Dexter 3,900 lb torsion axles use the same bearings as 3,500 lb axles. Which means the correct replacement bearing kit is the item #BK2-100 you were looking at. You'll need one set per hub. Your…

There are a couple of differences between the etrailer #AKEBRK-35-SA and the Dexter #23-468-469 brake assemblies. The pad on the etrailer brake is a little thick so that means the etrailer brakes will last a bit longer. Also, the etrailer brakes are…

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

The Electric Trailer Brake Kit part #AKEBRK-35-SA which is just part #AKEBRK-35L-SA and part #AKEBRK-35R-SA combined is made overseas. The Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-468-469 is made right here in the USA and are of a much…

On a 7-Way connector the suggested minimum wire gauge for the White (ground) wire, the Red or Black (power) wire, and the Blue (brake power) wire is 12 gauge. The minimum wire gauge for the remaining Green (right turn/brake) wire, the Yellow (left…

I have a solution for you but just the blue cap of the Kodiak XL ProLube Kit for 3500-lb Axles Item #XLPROLUBE1980KIT that you referenced is not available. So your best option would be the Kodiak XL ProLube Oil Bath Hub Body and Cap #xlprolube1980…

The only difference between the #RG06-050 and Timken #TMK58ZR is the brand and quantity. Timken is typically considered to be a high quality brand, particularly for their USA made bearings. The #RG06-050 comes with two seals so it is the better…

Hey Gabriel, since we know your 2016 Gulf Stream Vista Cruiser has 3,500 lb axles the correct bearing kit would be the part #BK2-100.