Replacement Parts for Jack System On 2008 Cameo by Carriage 5th Wheel

Question

Question:

Hello there, I have a 38’ 2008 Cameo by Carriage fifth wheel 16F62E5R781A09070 and am having trouble with the front feet jack system. It labors immensely. I rewired the switch directly to the battery and that did not help. I am wondering if you can tell me if the motor that is on it is the correct size. We purchased this rig 2 1/2 years ago and it has always struggled. Memorial weekend I had to lower the front way down to get it leveled and had to use bottle jacks to get it back up. I’ve attached a picture with the motor numbers on it along with a picture of the gearbox. I did get a handle - and it seems to raise and lower easily with it so I do t think gummed up gears is an issue either. Thanks for your help! David

asked by: David A

0

Expert Reply:

Hey David! Thanks for the pictures. Since it works just fine with the handle I would say the motor is definitely the issue. The Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs # LG-142178 is the best option to replace your 8532-07.

expert reply by: Robin H

0

Answer 1

There is a heavier-duty option to replace the Venture M-9000-PK landing gear motor than the 5,000 lb capacity Lippert Venture 5th Wheel RV Landing Gear Motor #LC142178. While that is the correct fit, if you want a higher rated capacity you can…

view full answer...

Answer 2

Hey Jerry, so the replacement motor #LG-142178 that you have now is rated for a lower weight capacity than the part #LC196308 that you mentioned so it would give you additional capacity and allow the landing gear to work easier. To know if the gear…

view full answer...

Answer 3

Happy to help Richard, thanks for reaching out! Yes, the Stromberg Carlson High Speed Replacement Motor #SC68QR will work as a replacement for your 8532-07 landing gear motor, as long as your landing gear is a Lippert or Venture system. This…

view full answer...

Answer 4

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 5

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

view full answer...

Answer 6

Thanks for the picture! We sure do! You will want the Replacement Motor for Stromberg Carlson Electric Landing Gear item #LG-142178.

view full answer...

Answer 7

We have the same part number basically twice through two different vendors here that are the exact replacement motor you are looking for. The Lippert part #LC142178 and the Stromberg part #LG-142178. They are the exact same motors and if I were you I…

view full answer...

Answer 8

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 9

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 10

Hey Johnny, thanks for reaching out! I highly recommend using the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor #LC196308 as a replacement for your 8532-07 motor. According to my research your motor is rated for 5,500 lbs so this motor will…

view full answer...

Replacement Parts for Jack System On 2008 Cameo by Carriage 5th Wheel

Product Page this Question was Asked From

Continue Researching